Miele S179i important safety instructions Replacing the Dust BAG, Filter Care

CAUTION: DISCONNECT THE CLEANER FROM THE OUTLET BEFORE PERFORMING THE OPERATIONS BELOW

REPLACING THE DUST BAG

1)Push the release button on the dust cover as shown, and pull it forward.

2)Grip the cardboard on the dust bag and pull out.

3)Install the dust bag by pressing the cardboard as shown. Before replacing the dust cover, make sure all the edges of the dust bag are completely inside the compartment.

4)Replace the dust cover by inserting the tab into the body slot then push the top of the cover into place.

NOTE: If the dust bag is not installed correctly, the dust cover will not close.

We recommend the use of genuine Miele paper bags only; Part # 5294740 Type Z

FILTER CARE

Fig. 1

In addition to the dust bag, the vacuum cleaner contains two filters; a central filter that protects the motor (Fig.1) and an Advanced Micron Filter, "Clean air filter" that removes particles from the exhausted air (Fig. 2).

The Advanced Micron Filter should be changed every six months or whenever it becomes dirty. The central filter should be changed or rinsed out whenever the Advanced Micron Filter is replaced.

IMPORTANT: Do not forget to re-install the filters before use.

Fig. 2

CENTRAL FILTER (Fig. 1)

Part # F03M1000

To remove, slide the central filter forward out of this housing.

IMPORTANT: If the central filter has been rinsed out, make sure it is dry before re-installing it.

ADVANCED MICRON FILTER (Fig. 2)

Part # S02R5000

To change the Advanced Micron Filter, simply remove the exhaust cover as shown and replace the filter.

– 8 –