Correcting minor faults | Problem solving guide | ||
|
|
|
|
|
|
|
|
What to do if, . . . ? | Cause . . . |
| Remedy . . . |
|
|
| |
. . . the drum door opens | The machine has overheated. | Before restarting the program, | |
during the drying cycle? | The temperature limiter |
| proceed as follows: |
| opened the drum door and | – Release the ON/OFF button. | |
| caused the machine to turn off | – Clean the affected part of the | |
| automatically. |
| machine. |
| Possible reasons for |
| – Turn on the machine again. |
| overheating: |
| – Reselect the terminated |
| – The lint filter in the door is | program. | |
| clogged. |
| – Press the “Start” button. |
| – The vent duct is blocked. |
| |
| If the drum door opens again, | ||
|
|
| |
|
|
| the Miele Service Dept. should |
|
|
| be contacted. |
|
|
| |
. . . drops of the water appear | This may not be a problem. A | These two seals may | |
along the upper edge of the | dual filter system with two | occasionally cause | |
drum door? | seals is used to prevent lint | condensed water to form on | |
| from becoming deposited in | the door. | |
| the heat exchanger. |
| Laundry coming into contact |
|
|
| with these drops of water will |
|
|
| dry within in a few minutes. |
|
|
|
|
. . . after cleaning the heat |
|
| Check that the heat exchanger |
exchanger, water leaks from |
|
| door has been replaced |
the machine? |
|
| correctly. If necessary, remove |
|
|
| and replace it. |
. . . the interior drum light |
|
| See next page. |
fails to function? |
|
|
|
|
|
|
|
. . . you have to open the |
|
| See next page. |
door in the event of a power |
|
|
|
failure? |
|
|
|
|
|
|
|
19
