Installation

Installation site

Installation beneath a counter

,Do not install the dryer in an area where it can be blocked, e.g. behind a door.

Transporting the dryer to the installation site

The rear excess end of the lid has a handle box for transport.

^Use the front dryer feet and the rear excess end to transport the dryer from the packaging base to the installation site.

,When the machine lid needs to be removed to reduce the height of the machine, a built under spacer kit* is necessary.

It must be installed by a Miele Service Technician.

The cover plate of the built under kit replaces the appliance lid and ensures electrical safety.

An installation manual is supplied with the built-under spacer kit.

The electrical connection should be near the dryer and accessible at all times.

Extended machine feet* are recommended at a built-in height of more that 33 1/16" (840 mm).

^Set the extended machine feet on a height of 1 9/16" (40 mm).

Remove the original machine feet and replace them with the extended ones.

One or two filler frames* are

recommended at a niche height of 34 1/4" / 34 13/16" to 36" / 36 5/8" (870/885 - 915/930 mm).

* (optional accessory)

An existing continuous toe kick must be interrupted at the dryer location!

Reinstallation of the machine lid

When reinstalling the appliance lid, check the firm fit of the cover at the rear bracket for a safe transport of the dryer.

31

Page 35
Image 35
Miele T 8019 C Installation site Installation beneath a counter, Transporting the dryer to the installation site