Milan Technology MIL-140TRM About this Manual, Introduction, Features, Operating Conditions

About this Manual

This document covers both the MIL-140CRM and the MIL-140TRM media converter modules. The terms “MIL-140” and “converter” are used throughout this document to describe these devices.

Introduction

The MIL-140 converters are part of a series of modules designed to be installed into MiLAN's Media Conversion System. These half-/full-duplex devices convert Ethernet optical signals to electrical and vice- versa.

The converter has a signal capability of transmitting up to 2 km (subject to fiber budget and collision domain restrictions). This module also has the Link Sentry feature.

Features

•One RJ-45 (UTP) connector

•One multi-mode, SC or ST fiber connector

•Link Sentry feature

•Diagnostic LEDs

•Management ready–supplied by MiLAN’s optional SNMP modules (MIL-4650 and MIL-4655)

•Power supply equipped on the rack mount chassis

Installation Guide: MIL-140TRM

1 2 3 4 5 6 7 8

Figure 2. RJ-45 Pinouts

Fiber Specifications: SC and ST Connector

•850 nm multi-mode fiber

•62.5/125 multi-mode fiber

•Launch power: -19 dBm

•Receive sensitivity: -34 dBm

Operating Conditions

Table 2: Recommended Operation Conditions

Parameters	Minimum	Maximum
Operating Temperature	+5° C	+50° C
Humidity: Non-condensing	10%	95%
Signal Output Load	35 ohm	75 ohm
Supply Voltage	4.75 V	5.25 V

2 7