Page 5
55 – Outboard Barrier in Not Up When the Outboard
Barrier Latch is Down
56 – Outboard Barrier is Not Latched and trying to go
down after the hand control button has been re-
leased. Must reset by pressing the Up button until
the outboard barrier is latched, then press down
so the platform goes to the ground level and the
outboard barrier is deployed
75 – Low Voltage Detected; must turn off power switch
to reset LCD
77 – Vehicle Secure Interlock has not been activated
99 – Controller Program is not Valid; Replace Controller
Flashing Numbers
Flashing 65 – Unfold button is pressed
Flashing 66 – Fold button is pressed
Flashing 67 – Down button is pressed
Flashing 68 – Up button is pressed
Flashing 69 – Bridge switch is activated
Flashing 70 – Outboard barrier latch switch is activated
Flashing 72 – Outboard barrier up switch is activated
Flashing 73 – Inboard barrier up switch is activated
Flashing 74 – Inboard barrier occupied switch is acti-
vated
Flashing 76 – Outboard barrier occupied switch is
activated
Flashing 78 – Threshold tape switch “A” is activated
Flashing 79 – Threshold tape switch “B” is activated
Flashing 83 – Tower #1 switch is activated
Flashing 84 – Tower #2 switch is activated
Flashing 85 – Tower #3 switch is activated
Flashing 86 – Tower #4 switch is activated
LCD Error Codes
Listed below are codes that the lift controller outputs
during lift operation. The codes will be displayed
on an LCD screen located on the lift control board
inside the pump module. See the Manual Operating
Instructions in the operator's manual for pump cover
removal instructions.

Millennium LCD Error Codes

Non-Flashing Numbers
01 – Platform Stowed
02 – Platform Unfolding
03 – Platform Unfolding Paused
04 – Platform at Floor Level
05 – Platform Beginning to Lower
06 – Platform Lowering (Threshold Cannot Be Occu-
pied from this Point Down)
07 – Outer Barrier Moving to Horizontal Position
08 – Platform at Ground Level
09 – Outer Barrier Moving to Vertical Position
10 – Platform Raising
11 – Platform Raising Paused at Floor
12 – Platform Folding (limited pressure)
13 – Platform Folding (full pressure)
14 – Timed Fold (Cinching Lift Tite) or (Anti-Rattle
State)
15 – Platform Folding Stopped
28 – Illegal Function/Not Defined
29 – Interlock Fault Not Recognized
30 – Platform Location Unknown
31 – Platform Location Transition State; Attempting to
Locate Position
50 – Outboard Barrier Is Not Up When Tower 4 LED Is
Not On
51 – Threshold is Occupied When Tower 2 LED Is Not
On
52 – Inboard Barrier Is Not Up and Locked When Tower
1 and Tower 4 LED’s Are On
53 – Inboard Barrier Occupied Sensor Is Not Activated
When Tower 1 and Tower 2 LED’s Are On
54 – Outboard Barrier is Occupied Before it is Up