Middleby Cooking Systems Group TCO21140077, TCO21140063 Off, Display Messages and Error Codes

I. DISPLAY MESSAGES AND ERROR CODES

DISPLAY SHOWS PROBLEM

ACTION

ENGLISH

Flashing tem- peratures or cook times dur- ing program- ming, and oven is beeping

OFF

- - - -

E-00 E-01

Set Temperatures or Cook Time Outside of Allowed Range

Heating Element turned off

No Menu Selection Chosen

Preset Menu Program Lost

High Ambient Condition Temperature inside the con- trol enclosure exceeds 65°C. The oven shuts down, then beeps continuously.

Re-enter the program using Set Temperatures and Cook Time within the allowed range. Also, refer to Part E, Programming Preset Menu Selections, in this Section.

If the element should be on, re-enter the program using Set Temperatures within the allowed range. Also, refer to Part E, Programming Preset Menu Selections, in this Section.

Choose or program a preset menu selection.

Re-enter the Preset Menu program.

Check the cooling fan (centered on the front panel of the oven) for cleanliness and proper operation. If the fan is not running after the oven heats, or the oven remains in a high ambient condition, contact your local Authorized Service Agent.

E-02	Conveyor Runaway
	The conveyor runs at full
	speed. The oven shuts down,
	then beeps continuously.
E-04	Conveyor Loose or Jammed
	Conveyor is stopped when
	the speed setting is between
	0:15 and 15:00.

E-35	Top Heating Zone Failure
E-36	Bottom Heating Zone Failure
E-40	Heating Zone Temperature
	High Limit

One or both of the heating zones have reached a tem- perature greater than 315°C.

Check for the proper speed setting by pressing . If the speed

setting is correct, and the conveyor continues to run at full speed, contact your Authorized Service Agent.

Switch the Power On/Off (I/O) Switch to the OFF (“O”) position. Switch the breaker/fused disconnect to the OFF position. Allow the oven to cool for at least 30 minutes.

CAUTION - HOT

DO NOT ATTEMPT TO FREE A JAMMED CONVEYOR BELT WHILE THE COOKING CHAMBER IS WARM. SEVERE INJURY MAY RESULT.

If the conveyor is jammed, free the obstruction from the conveyor belt. If the conveyor still will not operate properly after the jam is cleared, OR if the error message appears when the conveyor is NOT jammed, contact your local authorized service agent.

Contact your local authorized service agent.

Contact your local authorized service agent.

Contact your local authorized service agent.

10