Miller Camera Support 1025 manual Introduction Safety Instructions, Attaching/removing the camera

Introduction Safety Instructions

Thank you for purchasing the Arrow 40/55 Fluid Head. The Arrow 40 Fluid Head has been designed to suit payload capacities from ENG to standard configuration EFP cameras. The Arrow 55 Fluid Head has been designed to suit EFP and Studio cameras.

The robust design and construction of the Arrow 40/55 Fluid Head offers maximum stability, accuracy and durability and includes precision ball bearing mounted Fluid Drag Plate system in the Pan and Tilt assembly to deliver true fluid drag performance over the entire temperature and payload range.

The Fluid Drag and the Counterbalance system were designed to provide excellent control and repeatability and offer progressive equal increments of drag and torque.

The Arrow 40/55 Fluid Head also offers Illuminated single control location for operating Pan/Tilt, Counterbalance and viewing Bubble level.

The Arrow 40/55 Fluid Head will give best performance when used on a wide range of Miller tripods, including SOLO ENG (#1505), Sprinter II (#1589, #1580, #1576) and HD (#931) tripod. This will ensure maximum system stability to suit any professional set-up. The Arrow 40/55 Fluid Head will suit most industry standard 100 mm tripods as well, please refer to manufactures’ manual for mounting details.

Attaching/removing the camera

Please use this manual to familiarise yourself with the operation of the Arrow 40/55 Fluid Head and observe these instructions to prevent any damage to your equipment. Ensure that all equipment is operating correctly and free from defects and damage, also please ensure that the tripod is steady, secure and that the bowl is approximately horizontal when attaching the camera. The operator is responsible for the safe operation of this piece of equipment.

◗Do not exceed the maximum payload capacity of the Fluid Head.

◗Do not leave the camera unattended on the Fluid Head.

◗Do not release the SLIDING PLATFORM LOCK whilst the camera is at an angle.

◗Do not adjust the tripod whilst the camera is attached to the Fluid Head.

◗Ensure PAN HANDLE CLAMP and CLAMP NUT is securely tightened.

◗Apply TILT LOCK when adding/removing equipment from the camera or when attaching/removing the camera from the Fluid Head.

◗Hold camera securely whilst changing Counterbalance, Pan Drag or Tilt Drag settings.

◗Hold the camera securely whilst releasing the QUICK RELEASE KNOB.

◗Hold camera securely whilst adjusting the CLAMP NUT to level the Fluid Head.

2