Miller Camera Support 1505, 1630, 1501 manual Tripod Setup raised, Maximum Height, Minimum Height

Fig 3 Leg angle adjuster

TripodSetup raised

Fig 1 Collapsed position

Fig 2 Spread position

4

Remove tripod from carry bag, undo clip on leg strap and stand on a level surface (if possible). Depending on surface, screw out rubber foot for non-scratch contact to interior or hard surfaces or screw in for a spike on exterior soft surfaces such as dirt or sand.

Note: Leg angle adjusters are spring loaded and self adjusting. Do not hold leg angle adjuster up while spreading tripod legs as this may cause leg angle adjusters to operate improperly and potentially damage the tripod.

Maximum Height

(Leg angle adjustment is not required)

1Separate legs slightly so they are parallel.

2Working with each leg individually, grip concentric locks and release one turn (see leg lock direction label on leg).

3Extend to desired length and turn each concentric lock to engage firmly. Repeat process for remaining legs.

4Spread tripod legs (Fig. 2) and adjust leg length to ensure tripod bowl is approximately level.

5Level the fluid head using bubble level and ball levelling feature of fluid head.

Minimum Height

Note: It is recommended that minimum height position is used only with legs at their shortest length.

1Pull up leg angle adjuster until it locks into a raised position (Fig. 3). Repeat for all three locks.

2Holding one leg on the ground pull the remaining two outward, spreading the tripod to its lowest position. Leg angle adjuster will automatically engage the leg to hold

the tripod at its lowest height position (Fig. 4).

Fig 4 Lowest height position