![](/images/new-backgrounds/1240950/24095017x1.webp)
swarn8.1* 10/91
Turn Off cutter and remove input power. Remove top of cutter case.
1 Trigger Switch Connector
2 Gas Hose Connector
3 Pilot Lead Terminal
4 Boot
Insert hose and leads through boot.
5 Gas Hose
6 Pilot Terminal
Connect hose and leads as shown. Reinstall top of case.
Ref. ST-800 895 / ST-800 896
Keep away from moving parts.
SECTION 3 – INSTALLATION
3-1. Installing Hand-Held Torch
WARNING |
ELECTRIC SHOCK can kill. | HOT PARTS can cause severe burns. |
• Do not touch live electrical parts. | • Allow cooling period before maintaining or servicing. |
•Turn Off cutter, and disconnect input power before installing torch.
MOVING PARTS can cause injury.
•
Significant DC voltage can remain on capacitors in cutter after unit is Off. Always discharge capacitors according to cutter’s Owner’s Manual before installing torch.
1
2 3
Rear Panel
4
2 | 1 | 5 |
6 4
Tools Needed:
3/8, 5/8 in