Milwaukee 2281-20 manual EN Technical Data, Message Codes, Care

EN Technical Data

Distance measurement

Typical Measuring Tolerance* ± 1.5 mm / 0.06 in ***

Maximum Measuring	± 2.5 mm / 0.10 in ***
Tolerance**
Range of target plate	60 m / 197 ft
Typical Range*	60 m / 197 ft
Range at unfavourable	50 m / 164 ft
condition ****
Smallest unit displayed	0.1 mm / 1/32 in
Ø laser point	6 / 30 / 40 mm
at distances	(10 / 50 / 60 m)

General

Laser class	2
Laser type	635 nm, < 1 mW
Protection class	IP54 (dust- and splash
	water protected)
Autom. laser switch off	after 90 s
Autom. power switch-off	after 180 s
Battery durability (2 x AAA)	up to 5000 measure-
	ments
Dimension (H x D x W)	117 x 57 x 32 mm
	4.6 x 2.4 x 1.3 in
Weight (with batteries)	0.14 kg / 4.938 oz
Temperature range:	-25 to 70 °C
- Storage
- Operation	-13 to 158 °F
	-10 to 50 °C
	14 to 122 °F

*applies for 100 % target reflectivity (white painted wall), low background illumination, 25 ºC

**applies for 10 to 500 % target reflectivity, high back- ground illumination, - 10 ºC to + 50 ºC

***Tolerances apply from 0.05 m to 10 m with a confi- dence level of 95%. The maximum tolerance may deteriorate to 0.1 mm/m between 10 m to 30 m and to 0.2 mm/m for distances above 30 m

****applies for 100 % target reflectivity, background illumination of approximately 30'000 lux

Functions

Distance measuring	yes
Min/Max measuring	yes
Permanent measuring	yes
Stake-out	yes
Addition/Subtraction	yes
Area	yes
Volume	yes
Pythagoras	2-point, 3-point
Memory	10 displays
Beep	yes
Illuminated display	yes
Multifunctional endpiece	yes

Message Codes

If the message Error does not disappear after switching on the device repeatedly, contact the dealer.

If the message InFo appears with a number, press the Clear button and observe the following instructions:

No.	Cause	Correction
204	Calculation error	Perform measurement
		again.
252	Temperature too	Let device cool down.
	high
253	Temperature too	Warm device up.
	low
255	Received signal too	Change target surface
	weak, measuring	(e.g. white paper).
	time too long
256	Received signal too	Change target surface
	high	(e.g. white paper).
257	Too much back-	Shadow target area.
	ground light
258	Measurement	Correct range.
	outside of meas-
	uring range

260Laser beam inter- Repeat measurement. rupted

Care

•Clean the device with a damp, soft cloth.

•Never immerse the device in water.

•Never use aggressive cleaning agents or solvents.

14 Milwaukee 2281-20