Milwaukee 58-14-1025 manual Functional Description Tool Assembly, Selecting Blade

FUNCTIONAL DESCRIPTION

TOOL ASSEMBLY

		16
		17
	18		19
1.	Lock-off button	13.	Transparent front guard
2.	Trigger	14.	Upper guard
3.	Handle	15.	Front handle
4.	Battery pack release buttons	16.	Wrench
5.	Battery	17.	Spindle lock button

WARNING

Recharge only with the charger specified for the battery pack. For specific charging instructions, read the operator's manual supplied with your charger and battery pack.

WARNING

To reduce the risk of injury, always lock trigger or remove battery pack before changing or removing acces- sories. Only use accessories spe- cifically recommended for this tool. Others may be hazardous.

Selecting Blade

Select a blade appropriate for your applica- tion. Refer to the “Accessories” section for a list of blades to be used for the proper applications of this tool.

Always use sharp blades. Dull blades tend to overload the tool and increase the chance of KICKBACK. Only use thin kerf blades with a maximum safe operating speed greater than the no load RPM marked on the tool's nameplate. Read the blade manufacturer's instructions before use. Do not use any type of abrasive cut-off wheel or dry diamond cutting blades. Use the correct blade type for your application. Using the wrong blade may result in reduced performance or dam- age to the blade. Do not use blades that are cracked or have broken teeth. Do not sharpen ferrous metal cutting blades; see

6.	Shoe	18.	Depth adjusting lever
7.	Lower guard lever	19.	Overload protector
8.	Lower guard		1
9.	Blade bolt
			2
10.	Blade flange
			3
11.	Blade
12.	LED		4	5
15

Fig. 1

Inserting a battery pack

Removing a battery pack

the blade manufacturer's recommendations regarding sharpening.

Installing and Removing Blades

1.	Remove battery pack.
2.	Place the saw on a flat surface with the
	blade facing upwards. To remove the
	bolt from the spindle, push in the spindle
	lock button. While holding in the spindle

14
13
12
			6
			7
11	10	9	8

Removing Battery Pack from Tool

Push in the release buttons and pull the battery pack away from the tool.

Inserting Battery Pack into Tool

To insert the battery pack onto the tool, slide the pack onto the body of the tool. Make sure it latches securely into place.

lock button, use the wrench provided

with the tool to turn the bolt clockwise

(Fig. 2). Remove the bolt and blade

flange.

Fig. 2

6

7