Milwaukee AG 750-125, AG 750-100 manual 2020

TheMAINSworkpieceCONNECTIONmust be ¿xed if it is not heavy enough to be			SYMBOLS
steady. Never lead the workpiece to the grinding disk with
Connect only to single-phase a.c. current and only to the
your hand.				Please read the instructions carefully
system voltage indicated on the rating plate. It is also possible
toUnderconnectextremeto socketsconditionswithout(e.gan.smoothearthin-grindingcontactmetalsas thewith				before starting the machine.
designthe arbourconformsand vulcanizedto safety class¿bre grindingII.		wheel), signi¿cant
contamination can build up on the inside of the angle grinder.
MAINTENANCEFor safety reasons, in such conditions the inside should be
cleaned thoroughly of metal deposits and a motor circuit-				Always wear goggles when using the machine.
The ventilation slots of the machine must be kept clear at all
breaker must be connected in series. If the motor circuit-
times.
breaker trips the machine must be sent for repair.
Use only Milwaukee accessories and spare parts. Should
For accessories intended to be ¿tted with threaded hole
components need to be exchanged which have not been
wheel, ensure that the thread in the wheel is long enough to				Always disconnect the plug from the socket
described, please contact one of our Milwaukee service				before carrying out any work on the machine.
accept the spindle length.
agents (see our list of guarantee/service addresses).
For cutting or separating use a closed protection cap,
If needed, an exploded view of the tool can be ordered.
available as an accessory.
Please state the ten-digit No. as well as the machine type
printed on the label and order the drawing at your local				Accessory - Not included in standard equipment,
SPECIFIED CONDITIONS OF USE				available as an accessory.
service agents or directly at: Milwaukee Electric Tool,
MaxThe -angleEyth-Straßgrinder10,canDbe-71364usedWinnenden,tocut and roughGermany-grind. many
different materials, e.g. metal or stone, for grinding with a				Do not dispose of electric tools together with
plastic grinding plate and for operation with the wire brush.
Always follow the manufacturer’s instructions if you are				household waste material! In observance of
unsure about anything to do with the machine..				European Directive 2002/96/EC on waste
Do not use this product in any other way as stated for normal				electrical and electronic equipment and its
				implementation in accordance with national law,
use.
				electric tools that have reached the end of their
EC-DECLARATION OF CONFORMITY				life must be collected separately and returned to
				an environmentally compatible recycling facility.
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized
documents. EN 60745, EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3, in accordance with the regulations 98/37/
EC, 2004/108/EC
Winnenden, 2009-10-05	Rainer Kumpf
Manager Product Development
MAINS CONNECTION
Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also possible
to connect to sockets without an earthing contact as the
design conforms to safety class	II.
MAINTENANCE

The ventilation slots of the machine must be kept clear at all times.

Use only Milwaukee accessories and spare parts. Should components need to be exchanged which have not been described, please contact one of our Milwaukee service agents (see our list of guarantee/service addresses).

If needed, an exploded view of the tool can be ordered. Please state the ten-digit No. as well as the machine type printed on the label and order the drawing at your local service agents or directly at: Milwaukee Electric Tool, Max-Eyth-Straße 10, D-71364 Winnenden, Germany.

2020