
5.To remove the guard, unplug tool and place it upside down on a level surface. Remove any accessories from spindle.
6.Press in the lock lever and rotate the guard to line up the four tabs with the four slots as shown in (Fig. 4).
7.Lift the guard straight up and away from the tool.
8.To adjust the guard, press in the lock lever and rotate the guard to one of the five detents (Fig. 3).
Grinding
WARNING!
A Type “27” guard must be installed when using a grinding wheel to provide maximum protection for the operator if the wheel should break.
Selecting Wheels
Grinding is the cutting action of thousands of abrasive grains on the face of a grinding wheel. When grinding metals such as steel and iron, choose an aluminum oxide grinding wheel. Select a silicon carbide grinding wheel for stone and concrete. Use cotton reinforced wheels for
Type 27 reinforced 1/8"
Installing Grinding Wheels (Fig. 5 & 6)
Fig. 5
Flange nut
Boss
Spindle
Grinding wheel
Flange
Flange nut position for 1/4" thick wheels
Fig. 6
Flange nut
Boss
Spindle
Grinding wheel
Flange
Flange nut position for 1/8" or less thick wheels
1.When guard is properly positioned, place flange on spindle with flange facing away from tool.
WARNING!
To reduce the risk of injury, do not use the spindle lock button to stop the spindle while the tool is in use or is coasting after
2.Place selected wheel on spindle and align with flange. Position flange nut according to wheel thickness as shown (Fig. 5 & 6).
3.Press the spindle lock button while turning flange nut clockwise. Tighten securely with the spanner wrench provided.
4.To remove wheel, unplug tool and reverse procedure.
Grinding (Fig. 7 & 8)
Fig. 7
Operator's Zones
1.Depending on your job, position the guard to provide maximum pro- tection for the operator (Fig. 7).
2.If you have just installed a grinding wheel or are just beginning a period of work, test wheel by letting it spin for one minute before applying it to the workpiece.
NOTE:
3.Firmly grasp body of tool and side handle before starting and while using tool. Allow wheel to come to full speed before starting to grind.
Fig. 8
Hold at a 5° to 15° angle
4.When grinding, hold sander/grinder at a 5o to 15o angle as shown, using constant pressure for a uniform finish. Too great an angle causes concentrated pressure on small areas which may gouge or burn work surface.
5.Control pressure and surface contact between disc and workpiece. Too much pressure slows cutting speed.
page 7