Tiger JD 62-6420 manual Safety Light Assembly, Safety Light Installation, Description

SAFETY LIGHT ASSEMBLY

SAFETY LIGHT INSTALLATION

1.Install marker light asy onto the mounting bracket, running wires inside bracket tube.

2.Remove and retain panel under right rear fender that protects wiring.

3.Remove and discard back three screws and clips securing the right rear fender to the cab.

4.Install mtg. bracket to points in previous step with three 1/4" x 3/4”NC bolts and nylock nuts.

5.Using the mounting bracket as a template to drill two holes (13/64 dia.) and tap(1/4"NC) in the wheel well (Note: Use caution not to drill into the filter housing located behind the cab).

6.Secure bottom of mounting Bracket to wheel well with two 1/4" x 3/4"NC bolts and lockwashers.

7.Next remove the top cover of the tractor cab.

8.Drill two holes 5/8" dia, one in the fender under the air duct at the right rear corner of the cab and the other at the right rear corner of the cab just inside the air duct.

9.Install grommets in the 5/8 “ dia holes.

10.Route wire from mounting bracket into the area that will be covered by the panel removed in step 2, then through grommets and up into area above cab, install wires ends into connector shell and close strain relief (Note: Green wire to green wire when mated with adapter harness).

11.Splice the green wire from the adapter harness into the purple wire coming from right rear hazard light using heat shrink butt connector.

12.Splice the black wire from the adapter harness into the black wire coming from right rear hazard light using heat shrink butt connector.

13.Connect the adapter harness to the marker light harness.

14.Test for proper operation, the marker light should flash with hazards & right turn signal but should burn steady when left turn signal is in use.

15.Reinstall top cover of tractor cab and panel in fender to protect wiring.

ITEM	P/N	QTY	DESCRIPTION
*	06200420	AVAIL	SAFETY LIGHT KIT (INCLUDES ITEMS 1 THRU 9)
1	34800	1	MOUNT,JD62-6420,ASAE 279.11
2	21529	5	CAPSCREW,1/4" X 3/4" NC
3	21527	3	NUT,NYLOCK,1/4" NC
4	34859	1	MARKER LIGHT ASY
5	21986	2	LOCKWASHER 1/4”
6	31592	2	GROMMET, RUBBER, 5/16 X 13/16
7	35164	1	ADAPTER HARNESS
8		2	CONNECTOR, BUTT H-SHRINK
9	6T1824	2	ZIP TIE (NOT SHOWN)	03-01-05
		Parts Section 5-23