Tiger JD 62-6420 manual Assembly - Clean Cutter, Clean Cutter Blade Mounting

ASSEMBLY - CLEAN CUTTER

Failure to follow the following warnings and instructions may result in serious injury or damage to the equipment or property!

WARNING: The blade alone weighs approximately 145 lbs. Be sure its weight can be supported before attempting to replace. The use of a lift mechanism will ease replacement.

CLEAN CUTTER BLADE MOUNTING

The CLEAN CUTTER blade was designed for installation onto a standard TRB50 spindle. It is equipped with replaceable carbide tipped teeth. Carbide is very hard, it will chip or break on inpact. Handle the saw blade with care. DO NOT roll saw on any hard surface or allow it to strike a hard object. Set it down on a piece of belting or wood to avoid damaging carbide tips. Install two temperary(2) threaded studs into (2) opposite holes in the spindle. Align the bolt holes in adapter (part number 33875) with the studs and slide adapter over studs, be sure to index adaper so as the protruding 2 7/8” diameter pilot on the adapter faces outward away from spindle. Then slide the saw blade (part number 33874) over the studs and onto the 2 7/8” diameter pilot of the adapter. NOTE: Orient blade for clockwise rotation (blade rotates clockwise when looking down on top of mower deck). Then slide the collar (part number 33876) over the studs with the chamfered edge of collar to the outside, be sure the counterbore bolt holes face outward. Apply Loctite “271” to the threads of the 5/8-18 x 3” UNF Grade 8 bolts (part number 33877), and install lock washers (part number 21992) onto the bolts, then install bolts through collar, blade, and adapter into the spindle. Remove the threaded studs, and replace with bolts and lockwashers. Torque bolts in an alternating pattern to 184 Ft-lbs.

DANGER!	Never work under the Implement, the framework, or any lifted
	component unless the Implement is securely supported or blocked
	up to prevent sudden or inadvertent falling which could cause
	serious injury or even death. (SG-14)

Bengal Brute Common Section 6 - 68