Tiger JD 62-6420 manual Assembly Polycarbonate Safety Window

ASSEMBLY

POLYCARBONATE SAFETY WINDOW

NOTE: Installing a boom mower requires that all of the right side windows be replaced, or protected with a polycarbonate window. This should be done before mounting the main frame.

1.Disconnect gas shock at door. Remove the right side cab door/window glass from tractor cab by removing hinge pins. Also, remove rear right side window.

2.Remove the existing hardware and discard factory glass door and window.

3.Place small beed of adhesive seal in the botom of the trim lock bubble beed.

4.Install trim lock bubble seal on polycarbonate starting at the center bottom horizontal portion.

5.Install existing hardware removed from glass door and window on the polycarbonate.

6.Install the polycarbonate assembly in the cab with existing and supplied hardware.

7.Place the retaining brackets on the upper front and lower front of the cab door/window with the 8mm capscrews.

8.Place the third bracket at the bottom of the door by the fender as shown in the illustration below. Hold the bracket in place and mark the door jam.

9.Drill 21/64” hole in the door jam for the 5/16” capscrew and mount the bracket.

10.Install the right rear poly window into place where factory window was removed.

Assembly Section 2-6