Tiger JD 62-6420 manual Assembly Main Frame Installation, Valve Mounting Plate

ASSEMBLY

MAIN FRAME INSTALLATION

With an overhead hoist and / or jack-stands, raise one side of the frame up to the correctly matching mounting holes. Install capscrews and all other hardware as shown in main frame parts section to secure the sides of the main frame to the tractor casting, DO NOT tighten at this time. Remove the capscrews one at a time and apply a thread locking agent. Reinsert the capscrews and tighten / torque to values noted in the torque chart located in the maintenance section of this manual.

VALVE MOUNTING PLATE

Align the mounting bracket to the existing holes on top of the tractor remote valve at the rear of the tractor. Secure the bracket to the tractor with the hardware shown in the parts section of the manual. Attach the valve mounting plate to the valve mounting bracket on the rear of the tractor as shown below. Then place and secure the lift valve on top of the valve plate, in the position shown in the parts section. Install the control cables to the valve and route the hydraulic lines from the lift valve to the hydraulic cylinders as noted on the lift valve page of the parts section.

HUSCO

VALVE

DANFOSS

VALVE

Assembly Section 2-7