Mitel 3000
Getting Started Guide
Additional Extension Settings
The following parameters may be also be set on an
25 Hz | This allows the ringing frequency to be changed from 50 to 25 Hz. |
| The default setting is 50Hz however some older phone equipment |
| may require 25 Hz for ringing. This setting should only be applied if a |
| telephone does not ring correctly at 50 Hz. |
3.1 kHz Station | Allows an outgoing call to be set for 3.1Khz minimum bandwidth. It is |
| advisable to set this for Fax or Modem calls out over ISDN lines |
Extension Disconnect | No dial tone is supplied to the extension and it cannot be used. This |
| is generally used if an unoccupied office is equipped with a phone |
| that will be turned on for use at some future date. |
Hot Line | Allows an extension to be set to call a |
| when the extension goes off hook. Typically used for unsupervised |
| reception areas or fax machines. |
Individual Caller ID | The Administrator can decide which extensions have individual |
Lists | Caller ID Lists. |
Keypad Confirmation | Allows the keypad tones to be switched on/off on an |
| extension basis. |
Manager/Assistant | Allows specific features to be mapped between a manager and |
| assistant for improved functionality. |
No Call Logging | Prevents calls to and from this extension being stored in the Station |
| Message Detail Recorder (SMDR) log. |
External Diversions | This prevents or allows extensions to forward their calls externally. It |
| also allows or prevents an extension from using external transfer or |
| conference with two lines and an extension. |
Open Door Restriction An extension can be restricted from opening the door if a remote door opening system is installed.
Page Protect | Removes an extension from the paging group. |
Port Swapping | Allows two extensions to be swapped on the system for |
| administration or programming purposes. |
Permanent CLIR | Allows a station to be set so that it never sends the CLI number |
| when making an outgoing call (CLIR) |
Permanent COLR | Allows a station to be set so that it never shows the CLI number |
| during a connected incoming call (COLR) |
Restrict use of PA | Prevents an extension from accessing the optional PA system if |
| connected to the system. |
27
