Roland XV-5080 owner manual Copying Effect Settings, 106, Copy Type, When Using 3D Effects

Chapter 2 Using the XV-5080 Effects

When Using 3D Effects

The following 3D effects utilize RSS (Roland Sound Space) technology to create a spaciousness that cannot be produced by delay, reverb, chorus, etc.

48:3D DELAY

60:3D CHORUS

61:3D FLANGER

70:3D DELAY 2

89:3D AUTO SPIN

90:3D MANUAL

When using these effects, we recommend that you place your speakers as follows. Also, make sure that the speakers are at a sufficient distance from the walls on either side.

fig.02-031.e

30˚ 30˚

If the left and right speakers are too far apart, or if there is too much reverberation, the full 3D effect may not appear.

Each of these effects has an Out (Output Mode) parameter. If the sound from the OUTPUT jacks is to be heard through speakers, set this parameter to “Speaker.” If the sound is to be heard through headphones, set it to “Phones.” This will ensure that the optimal 3D effect will be heard. If this parameter is not set correctly, the full 3D effect may not appear.

Copying Effect Settings

You can copy the effect settings from any Patch, Performance, or Rhythm Set into the currently selected Patch, Performance, or Rhythm Set. This can save a great deal of time and effort when setting up effects.

You can select the following effect contents to be copied.

Copy Type

ALL: Multi-effects, Chorus, and Reverb settings

MFX: Multi-effects settings in the General page

CHORUS: Chorus settings

REVERB: Reverb settings

CHO&REV: Chorus and Reverb settings

*If the copy source is a Performance, the contents copied for “MFX” will be the Multi-effects settings for the Performance itself (the Multi-effects setting when MFX 1–3 Source is set to “PERFORM” in the General page). When the MFX settings such as patches is copied to the Performance, the data will be copied as the Multi-effects settings for the Performance itself.

1.Make sure the Patch, Performance or Rhythm Set is selected.

2.Press [SYSTEM/UTILITY] several times, getting its indicator to start blinking.

The Utility Menu page appears.

*When the indicator lights, you are in SYSTEM mode. In this case, press [SYSTEM/UTILITY] once again to get its indicator to start blinking.

3.Press [F2 (Copy)].

4.Press [ ] to move the cursor to Type, then select

EFFECT.

The corresponding Effect Copy page will appear.

Destination “Temporary” indicates that the copy destination is the currently selected Patch, Performance, or Rhythm Set.

5.Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you want to set.

6.Turn the VALUE dial or press [INC]/[DEC] to select the desired value.

7.Press [F6 (Copy)] to execute the copy.

8.Press [EXIT] to return to the Play page.

106