Roland XV-5080 owner manual 113, Mfx-A

SYSTEM General #1 page ([SYSTEM] - [F1 (General)])

Master

Level (Master Level)

Range: 0–127

Adjusts the volume of the entire XV-5080.

Example of Settings

Selecting Different Output Destinations for Parts in a Performance

This example describes the procedure for outputting Part 1 from the A (MIX) OUTPUT jacks without sending it through any internal effects, sending Part 2 through the Multi-effects A and then outputting it from the B OUTPUT jack, and outputting Part 3 from the INDIVIDUAL 5 OUTPUT jack without sending it through any internal effects.

First, set Part 1.

1.Select the Performance you wish to use.

2.Press [F6 (Effects)].

3.Press [F1 (General)] several times to call up the Performance Effects General #1 page.

4.Press PART SELECT [1/17] to make its indicator light.

*Make sure that the [1-16/17-32] button’s indicator is not lit. If the indicator is lit, press [1-16/17-32] to turn it off.

5.Press [ ]/[ ]/[ ]/[ ] to move the cursor to Part Output Assign.

6.Turn the VALUE dial or press [INC]/[DEC] to select “A.”

7.Press [ ]/[ ]/[ ]/[ ] to move the cursor to Part Dry Send Level.

8.Turn the VALUE dial to select “100.”

9.Press [ ]/[ ]/[ ]/[ ] to move the cursor to Part Chorus Send Level.

10.Turn the VALUE dial to select “0.”

11.Set the Part Reverb Send Level setting to “0” in the same way.

Next, set up Part 2.

12.Press PART SELECT [2/18], getting its indicator to light.

*Make sure that the [1-16/17-32] button’s indicator is not lit. If the indicator is lit, press [1-16/17-32] to turn it off.

Chapter 3 Selecting Output Jacks

13.Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you wish to set, and rotate the VALUE

dial, or press [INC] or [DEC] to set the value as follows.

Part Output	Part Dry	Part Chorus	Part Reverb
Assign	Send Level	Send Level	Send Level	Chap.3
MFX-A	100	0	0

The Part Dry Send Level can be set to any value you wish other than 0.

14. Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you wish to set, and rotate the VALUE dial, or press [INC] or [DEC] to set the value as follows.

MFX	MFX Dry	MFX Chorus	MFX Reverb
Output Assign	Level	Send Level	Send Level
B	100	0	0

Finally, set up Part 3.

15.Press PART SELECT [3/19], getting its indicator to light.

*Make sure that the [1-16/17-32] button’s indicator is not lit. If the indicator is lit, press [1-16/17-32] to turn it off.

16. Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you wish to set, and rotate the VALUE dial, or press [INC] or [DEC] to set the value as follows.

Part Output	Part Chorus	Part Reverb
Assign	Send Level	Send Level
5	0	0

The output level can be set to any value you wish other than 0.

17.Press [EXIT] to return to the PERFORM PLAY page.

113