Chapter 8 Saving Tones and Other Data You’ve Created

Source

You can specify the data to be transmitted by selecting the appropriate combination shown below.

For example, if you wish to transmit the USER group Patches 001–020, you would specify “PATCH USER: 001–020.”

TYPE

BLOCK

 

 

ALL

USER

 

 

 

TEMP

 

 

PERFORM

USER

01–64

 

 

TEMP

-PATCH

*1

 

 

+PATCH

*2

 

CTRL

 

 

PATCH

USER

001–128

 

 

TEMP

 

 

RHYTHM

USER

001–004

 

 

TEMP

 

 

SYSTEM

USER

 

 

*1 The current Performance

*2 The current Performance and the Patch or Rhythm Set assigned to each Part of the Performance

*ALL indicates all of the Patches, Performances, and Rhythm Sets in the following settings (USER or TEMP).

*When set to TEMP, data in the temporary area will be transmitted.

*When set to CTRL, the status of Performances, including Performance Bank Selects and Program Changes, are not sent as Exclusive messages, but rather as MIDI Channel messages. For more on the transmitted MIDI channel messages, refer to “MIDI Implementation.” (p. 282)

*It is not possible to transmit GM system settings.

Destination

As shown in the diagram, connect the XV-5080 to the external MIDI device before performing the procedure.

XV-5080

MIDI OUT

MIDI IN

Sequencer, etc.

1.Press [SYSTEM/UTILITY], getting its indicator to start blinking.

*If the indicator is steadily lit, you are in SYSTEM mode. Press [SYSTEM/UTILITY] once again, so the indicator is blinking.

2.Press [F6 (Menu)] to select Menu 2.

3.Press [F1 (Xfer)].

4.Press [F1 (To MIDI)].

5.Press []/[]/[]/[] to move the cursor to the parameter you want to set.

6.Turn the VALUE dial or press [INC] / [DEC] to select the desired value.

7.Press [F6 (Trans)] to execute the transmission.

* To cancel the operation, press [EXIT].

Transmitting to User Memory

You can transmit Patch, Performance or Rhythm Set settings to the USER memory and System settings to the System memory.

You can specify the data to be transmitted by selecting the appropriate combination shown below.

For example, if you wish to transmit only the PR-A group Patch 001, specify “PATCH PR-A: 001–001.”

If the selected data is too large to fit completely into the transmission destination, as much of the data as will fit will be transmitted, starting at the first number of the specified transmission destination.

(Example) Source

Type: PATCH

Block PR-A:001–005

Destination

User:127

If the above settings are made and transmission is executed, only the two PR-A group Patches 01 and 02 will be transmitted to USER group Patches 127 and 128.

204

Page 204
Image 204
Roland XV-5080 owner manual Destination, Transmitting to User Memory, 204, Source