Roland XV-5080 owner manual OVERDRIVE→ Flanger, OVERDRIVE→ Chorus

Output

Level (Output Level) #

Adjust the output level.

Chapter 2 Using the XV-5080 Effects

27: OVERDRIVE→ FLANGER

This effect connects an overdrive and a flanger in series.

Balance D

Chap.

26: OVERDRIVE→ CHORUS

L in

Feedback

L out

Balance W

2

This effect connects an overdrive and a chorus in series.

L in	L out
	Balance D
	Balance W
Overdrive	Chorus

Overdrive

R in

Flanger

Balance W

R out

Balance D

	Balance W
R in	R out
	Balance D

Overdrive

Drive

Adjust the degree of overdrive distortion. The volume will change together with the degree of distortion.

Pan (Overdrive Pan) #

Adjust the stereo location of the overdrive sound. L64 is far left, 0 is center, and 63R is far right.

Chorus

Pre Delay (Chorus Pre Delay Time)

Adjust the time delay from when the direct sound begins until the chorus sound is heard.

Rate (Chorus Rate)

Adjust the modulation speed of the chorus effect.

Depth (Depth Rate)

Adjust the modulation depth of the chorus effect.

Balance (Chorus Balance) #

Adjust the volume balance between the overdrive sound that is sent through the chorus and the overdrive sound that is not sent through the chorus. With a setting of “D100: 0W,” only the overdrive sound will be output. With a setting of “D0: 100W,” only the overdrive sound that is sent through the chorus will be output.

Output

Level (Output Level)

Adjust the output level.

Overdrive

Drive

Adjust the degree of overdrive distortion. The volume will change together with the degree of distortion.

Pan (Overdrive Pan) #

Adjust the stereo location of the overdrive sound. L64 is far left, 0 is center, and 63R is far right.

Flanger

Pre Delay (Flanger Pre Delay Time)

Adjust the time delay from when the direct sound begins until the flanger sound is heard.

Rate (Flanger Rate)

Adjust the modulation speed of the flanger effect.

Depth (Flanger Depth)

Adjust the modulation depth of the flanger effect.

Feedback (Flanger Feedback)

Adjust the proportion (%) of the flanger sound that is fed back into the effect. Negative (-) settings will invert the phase.

Balance (Flanger Balance) #

Adjust the volume balance between the overdrive sound that is sent through the flanger and the overdrive sound that is not sent through the flanger. With a setting of “D100: 0W,” only the overdrive sound will be output. With a setting of “D0: 100W,” only the overdrive sound that is sent through the flanger will be output.

Output

Level (Output Level)

Adjust the output level.

59