Roland XV-5080 Output-A 1/2-D 7/8 Low Frequency, Low Gain, High Frequency, High Gain, 211

Chapter 9 Other Settings/Status Checks

Making the Equalizer	* If you’ve made a mistake, simply press [UNDO]. The value of
Settings ([SYSTEM/UTILITY] -	the parameter will be restored to what it was when you first
	positioned the cursor there.
[F2 (Outp&EQ)] - [F2 (EQ)])	5. Press [EXIT] to return to the applicable PLAY page.
You can set the equalization for each of the output jacks.	Establishing the MIDI
* ON and OFF are applied to all of the equalizers as a group. (p.
24)	Settings ([SYSTEM/UTILITY] -
	[F3 (MIDI)])

Output-A (1/2)–D (7/8)
L.F (Low Frequency)
			Setting Procedure:
Range: 200/400 Hz			1.	Press [SYSTEM/UTILITY], and confirm that its indicator
Selects the frequency of the low range.				has lighted.
L.G (Low Gain)			*	If the indicator is blinking, you are in UTILITY mode. Press
				[SYSTEM/UTILITY] once again to get the indicator to light
Range: -15– +15				steadily.
Specifies the low-frequency gain (amount of boost or cut).			2.	Press [F3 (MIDI)] to call up the SYSTEM MIDI page.
Positive (+) settings will emphasize the low-frequency range.
			3.	Press [ ]/[ ]/[	]/[	] to move the cursor to
H.F (High Frequency)				the parameter you want to set.
Range: 2000/4000/8000 Hz			4.	Turn the VALUE dial or by press [INC]/[DEC], to select
Selects the frequency of the high range.				the desired value.
H.G (High Gain)			*	If you’ve made a mistake, simply press [UNDO]. The value of
				the parameter will be restored to what it was when you first
Range: -15– +15				positioned the cursor there.
Specifies the high-frequency gain (amount of boost or cut).			5.	Press [EXIT] to return to the applicable PLAY page.
Positive (+) settings will emphasize the high-frequency
range.
Setting Procedure:
1. Press [SYSTEM/UTILITY], and confirm that its indicator
has lighted.
* If the indicator is blinking, you are in UTILITY mode. Press
[SYSTEM/UTILITY] once again to get the indicator to light
steadily.
2. Press [F2 (Outp&EQ)] to call up the SYSTEM EQ page.
3. Press [ ]/[ ]/[	]/[	] to move the cursor to
the parameter you want to set.
4. Turn the VALUE dial or by press [INC]/[DEC] to select
the desired value.

Chap.9

211