Roland XV-5080 owner manual Making Chorus Settings

Chapter 2 Using the XV-5080 Effects

Making Chorus Settings

The XV-5080’s Chorus effect unit can also be used as a stereo delay unit.

These settings allow you to select chorus or delay, the characteristics of the selected effect type, and the Chorus output routing.

On the Effects General page, set the following parameters.

Chorus Type

0 (Off): Neither Chorus or Delay is used.

1 (Chrus): Chorus is used.

2 (Delay): Delay is used.

Chorus Output Select

This parameter allows you to send the Chorus output directly to the currently selected OUTPUT jacks, to the Reverb, or to both.

MAIN: The Chorus output is sent only to the OUTPUT jacks.

OUTPUT

REV: The Chorus output is sent only to the Reverb.

Chorus Input	Reverb
Chorus		OUTPUT

M+R: The Chorus output is sent to the OUTPUT jacks and to the Reverb.

Chorus Input	OUTPUT
Chorus
Reverb Input	OUTPUT
Reverb

Chorus Level 0–127

Determines the Chorus output level.

Chorus Output Assign A–D

Selects the pair of OUTPUT jacks to which the Chorus unit’s stereo output is routed when Chorus Output Select is set to “MAIN” or “M+R.”

Pressing [F4 (Chorus)] in the General page calls up the Chorus page, in which you can make the following settings.

•For Type: 1 (CHORUS)

Rate (Chorus Rate) 0.05–10.00 Hz

Adjusts the modulation speed of the chorus effect.

Depth (Chorus Depth) 0–127

Adjusts the modulation depth of the chorus effect.

Feedback (Chorus Feedback) 0–127

Specifies the amount of the chorus effect’s output to be returned - fed back - to its input. Higher settings will create a more complex Chorus effect.

Phase 0–180 degree

Adjusts the spatial spread of the sound.

Pre Delay (Chorus Pre Delay) 0.0–100 ms

Adjusts the delay time from the direct sound until when the chorus sound is heard.

Higher settings will make the sound more spacious.

Type (Filter Type)

Selects the type of filter.

OFF: No filter is used.

LPF: Frequencies higher than the selected cutoff frequency value are eliminated.

HPF: Frequencies lower than the selected cutoff frequency value are eliminated.

Cutoff freq (Cutoff Frequency) *1

Sets the cutoff frequency when a specific frequency band is cut off by a filter.

*1 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 Hz

38