Roland XV-5080 owner manual Rhythm Set Mode Settings, Following shows the basic setting procedure

Chapter 2 Using the XV-5080 Effects

Rhythm Set Mode Settings

You can apply Multi-effects, Chorus or Reverb to each of a Rhythm Set’s Tones. You can control the amount of effect to be applied to each Rhythm Tone by adjusting its send level to the Multi-effects, Chorus and Reverb.

Rhythm Set
	B1
D7	RHYTHM	Multi-Effects
	TONE
		Chorus
		Reverb

The primary role of the effect settings is to determine the Rhythm Tone Output Assign.

You can select from the following Rhythm Tone Output Assign settings values to suit your purposes.

MFX: Selected when Multi-effects, chorus, and reverb are used.

A-D:Selected when outputting in stereo without use of the Multi-effects. Chorus and reverb can be used.

1-8:Selected when outputting in mono without Multi- effects. Chorus and reverb can be used. When this setting is used, chorus and reverb sounds are output in stereo according to the Chorus Output Assign and Reverb Output Assign settings.

The screen appears as shown below, according to the settings values.

•For MFX

•For A–D

•For 1–8

The following shows the basic setting procedure.

1.Select the Rhythm Tone you wish to set.

2.Press [F6 (Effects)].

The Patch Effect page appears.

3.Press [F1 (General)].

The General page will appear.

4.Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you want to set.

5.Turn the VALUE dial or press [INC]/[DEC] to select the desired value.

*If you make a mistake when setting a parameter’s value, or you don’t like the change you have made, just press [UNDO] to restore the value the parameter originally had.

6.Repeat Steps 3 to 5 to set the Effect.

7.Press [EXIT] to return to the RHYTHM Play page.

A “*” symbol will appear at the left of the Rhythm Set name, indicating that its settings have been modified.

*If you turn off the power or select another Rhythm Set while the “*” symbol is displayed, your new Rhythm Set settings will be lost. If you wish to keep them, perform the Write operation. (p. 194)

*When [MFX], [CHO], or [REV] are turned off, effects processors that are turned off will be indicated by a dashed outline in the General page.

36