Do not force the unit’s power-supply cord to share an outlet with an unreasonable number of other devices. Be especially careful when using extension cords—the total power used by all devices you have connected to the extension cord’s outlet must never exceed the power rating (watts/amperes) for the extension cord. Excessive

loads can cause the insulation on the cord to heat up and eventually melt through.

..........................................................................................................

Before using the unit in a foreign country, consult with your retailer, the nearest Roland Service

Center, or an authorized Roland distributor, as listed on the "Information" page.

..........................................................................................................

Always turn the unit off and unplug the power

cord (QuickStart p. 8) before attempting instal- lation of the circuit board (SRX series, SR-JV80 series ; QuickStart p. 3).

The unit should be located so that its location or position does not interfere with its proper venti- lation.

..........................................................................................................

Always grasp only the plug on the power-supply

cord when plugging into, or unplugging from, an outlet or this unit.

..........................................................................................................

Try to prevent cords and cables from becoming entangled. Also, all cords and cables should be placed so they are out of the reach of children.

..........................................................................................................

Never climb on top of, nor place heavy objects on the unit.

..........................................................................................................

Never handle the power cord or its plugs with wet

hands when plugging into, or unplugging from, an outlet or this unit.

..........................................................................................................

Before moving the unit, disconnect the power

plug from the outlet, and pull out all cords from external devices.

..........................................................................................................

Before cleaning the unit, turn off the power and

unplug the power cord from the outlet (QuickStart p. 12).

..........................................................................................................

Whenever you suspect the possibility of lightning

in your area, pull the plug on the power cord out of the outlet.

..........................................................................................................

Install only the specified circuit board(s) (SRX series, SR-JV80 series). Remove only the specified screws (Quick Start p. 4).

..........................................................................................................

Should you remove the optical connector caps, make sure to put them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally.

..........................................................................................................

4

Page 4
Image 4
Roland XV-5080 owner manual