Troubleshooting

If no sound can be heard, or if the unit does not perform as you expect, check the following points first. If this does not resolve the problem, contact your dealer or a nearby Roland service station.

*If a message appears during operation, consult the following section (p. 235).

No sound

Is the VOLUME lowered?

Check the VOLUME knob, and the volume settings on the connected amp/mixer etc.

Have connections been made correctly?

If there is sound in the headphones, it is possible that the connection cables are broken, or that the amp or mixer is malfunctioning. Check the connection cables and other devices once again.

Is the MIDI receive channel correct?

Make sure that the MIDI transmit channel of the connected device matches the receive channel of theXV- 5080.

Are the Tone, Patch and Part level settings excessively low?

Check the level settings of each Tone, Patch and each Part.

Are Tones or Parts turned off?

Check the on/off settings of each Tone and each Part.

Are the key range settings correct?

Check the key range settings of each Tone and each Part.

Has the volume been lowered by volume/ expression messages received from an external device?

The volume will return to normal when the power is turned on once again. When a Performance or Rhythm Set is selected, the reception status for each type of message can be viewed in the PART INFO page. (p. 166, p. 228)

Are the effect settings correct?

Check settings such as Effect On/Off, and Effect Balance and Level.

Are the output destination settings correct?

Check the Output Assign and MFX Output Assign settings.

Can’t select Performances

Is [RX] on?

When [RX] is on in the PERFORM PLAY page, [A]—[H] (PART SELECT [1/9]—[8/16]) act as buttons which turn Parts on/off. Turn [RX] off.

Can’t select the Part for which to make settings

Is [RX] on?

When [RX] is on in the various Performance setting pages, PART SELECT [1/9]—[8/16] function as buttons to switch each Part on/off. Turn [RX] off.

Pitch is wrong

Is the Master Tune setting correct?

Check the setting. (p. 209)

Is Scale Tune selected?

Check the setting. (p. 209)

Are the pitch settings for each Tone and each Part correct?

’Check each setting.

Have pitch bend messages received from an external device caused the pitch to “stick”?

The pitch will return to normal when the power is turned on. If a Performance or Rhythm Set is selected, the PART INFO page allows you to check the reception status of each type of messages. (p. 166, p. 228)

232

Page 232
Image 232
Roland XV-5080 No sound, Can’t select Performances, Can’t select the Part for which to make settings, Pitch is wrong