Chapter 8 Saving Tones and Other Data You’ve Created

TYPE

BLOCK

 

 

ALL

PR-A, B

 

*1

PERFORM

USER *2

01–64

 

 

PR-A, B

01–32

 

 

CARD

01–64

*6

PATCH

USER *2

001–128

 

 

PR-A–G *3

001–128

 

 

CARD

001–128

*5

 

XP-A–H

 

*4

RHYTHM

USER *2

1–4

 

 

PR-A–G *3

1–2

 

 

CARD

1–4

*5

 

XP-A–H

 

*4

SYSTEM

CARD

 

*6

F-LIST

CARD

 

*6

*1 Since there are no others, Performances other than PR-A/B cannot be selected.

*2 Move data within the User Memory in block units. The Move destination Patch is overwritten.

*3 PR-H uses GM data, and cannot be transmitted.

*4 Depends on the Wave Expansion Board installed

*5 After designating the file, set the range specifications for the block being transmitted.

*6 Specify the file.

*If the number sent exceeds the capacity of the User memory, then transmission of the data stops the moment the memory is filled.

Destination

Set the number at the transfer-destination in "User." * You cannot select ALL, SYSTEM, or F-LIST.

The following shows the setting procedure.

1.Press [SYSTEM/UTILITY], getting its indicator to start blinking.

*If the indicator is steadily lit, you are in SYSTEM mode. Press [SYSTEM/UTILITY] once again, so the indicator is blinking.

2.Press [F6 (Menu)] to select Menu 2.

3.Press [F2 (Xfer)].

4.Press [F2 (to USER)].

5.Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you want to set.

6.Turn the VALUE dial or press [INC] / [DEC] to select the desired value.

7.Press [F6 (Trans)] to execute the transmission.

* To cancel the operation, press [EXIT].

Protecting the Internal Memory (Protect)

This feature helps prevent the accidental overwriting of USER memory to ensure that Patch, Performance or Rhythm Set data is not accidentally erased.

Internal Write Protect

The Internal Write Protect setting prevents the Write operation from accidentally overwriting USER memory locations. When this is set “ON,” the data cannot be written. Data can be only written when Internal Write Protect is set to “OFF.” When the XV-5080’s power is turned on, this setting is automatically turned on, —you will need to turn it off before writing data to the USER memory. It is also possible to turn this setting off during the Write procedure.

Exclusive Protect

The Exclusive Protect setting prevents System Exclusive messages received from an external MIDI device from rewriting USER memory settings. When this is set “ON,” the data cannot be written. Data can be only written when Internal Write Protect is set to “OFF.” When it is set to “OFF,” data can be rewritten, even if the Internal Write Protect setting is set to “ON.”

The following shows the setting procedure.

1.Press [SYSTEM/UTILITY], getting its indicator to start blinking.

*If the indicator is steadily lit, you are in SYSTEM mode. Press [SYSTEM/UTILITY] once again, so the indicator is blinking.

2.Press [F6 (Menu)] to select Menu 1.

3.Press [F5 (Protect)].

The User Memory Protect page will appear.

4.Press [ ]/[ ] to move the cursor to the parameter you wish to set.

5.Either by rotating the VALUE dial, or by pressing [INC]/ [DEC], select the save destination.

Chap.8

205

Page 205
Image 205
Roland XV-5080 owner manual Protecting the Internal Memory Protect, 205, Internal Write Protect, Exclusive Protect