82
Chapter 2 Using the XV-5080 Effects
amount of time. Setting this higher than 50 increases the time
for Vowel 1; setting this lower than 50 decreases the time for
Vowel 1.

Phase #

Sets the phase shift of the left and right sounds when the two
vowels are switched.
Keysync

Switch (Keysync Switch)

Determines whether the LFO for switching the vowels is
reset according to the input sound (ON) or not (OFF).

Thres

Adjusts the volume level at which reset will be applied.
EQ Gain

Low

Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.

High

Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Output
Level (Output Level)
Adjusts the output level.
67: MULTI TAP DELAY 2
This allows you to set even longer delay times (max. 3000
ms) for the Multi-Tap Delay function.
fig.02-067m.e
Delay

14 (Delay Time 14)

Adjusts the delay time from the direct sound until the delay 1
4sound is heard.
Feedback #
Adjusts the proportion (%) of the delay sound that is fed
back into the delay input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
HF Damp
Adjusts the frequency above which delayed sound fed back
to the delay input will be cut.
If you do not want to damp the high frequencies, set this
parameter to BYPASS.
Level

14 (Delay Level 14)

Adjusts the output level of delay 1 4.
Pan

14 (Output Pan 14)

Sets the stereo position of the delay sound (Delay 1 4). L64
is far left, 0 is center, and 63R is far right.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
High (High Gain)
Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Level (Output Level)
Adjusts the output level.
L in
R in
L out
R out
Multi Tap Delay
Balance W
Balance D
Balance W
Balance D
Delay 1
Delay 3
Delay 4
Delay 2
Feed
back
2-Band
EQ
2-Band
EQ