Roland XV-5080 owner manual ENHANCER→ Delay, CHORUS→ Delay

Chapter 2 Using the XV-5080 Effects

34: ENHANCER→ DELAY

This effect connects an enhancer and a delay in series.

L in	Enhancer	L out
	Mix	Balance D

Balance W

Delay

		Balance W
		Feedback
R in	Enhancer	R out
	Mix	Balance D

Enhancer

Sens #

Adjust the sensitivity of the enhancer.

Mix Level (Enhancer Mix Level)

Adjust the ratio with which the overtones generated by the enhancer are combined with the direct sound.

Delay

Time (Delay Time)

Adjust the time delay from when the direct sound begins until the delay sound is heard.

Feedback (Delay Feedback)

Adjust the proportion (%) of the delay sound that is fed back into the delay input. Negative (-) settings will invert the phase.

HF Damp (Delay HF Damp)

Adjust the frequency above which delayed sound fed back to the delay input will be cut. If you do not want to cut the high frequencies of the delay feedback, set this parameter to

BYPASS.

Balance (Delay Balance) #

Adjust the volume balance between the enhancer sound that is sent through the delay and the enhancer sound that is not sent through the delay. With a setting of “D100: 0W,” only the enhancer sound will be output. With a setting of “D0: 100W,” only the enhancer sound that is sent through the delay will be output.

Output

Level (Output Level)

Adjust the output level.

35: CHORUS→ DELAY

This effect connects a chorus and a delay unit in series.

Balance D

L in L out

Balance W	Balance D
	Balance W
Chorus	Delay

Balance W	Balance W
	Feedback
R in	R out
Balance D	Balance D

Chorus

Pre Delay (Chorus Pre Delay Time)

Adjust the time delay from when the direct sound begins until the chorus sound is heard.

Rate (Chorus Rate)

Adjust the modulation speed of the chorus effect.

Depth (Chorus Depth)

Adjust the modulation depth of the chorus effect.

Balance (Chorus Balance) #

Adjust the volume balance between the direct sound and the chorus sound. With a setting of “D100: 0W,” only the direct sound will be output. With a setting of “D0: 100W,” only the chorus sound will be output.

Delay

Time (Delay Time)

Adjust the time delay from when the direct sound begins until the delay sound is heard.

Feedback (Delay Feedback)

Adjust the proportion (%) of the delay sound that is fed back into the delay input. Negative (-) settings will invert the phase.

HF Damp (Delay HF Damp)

Adjust the frequency above which delayed sound fed back to the delay input will be cut. If you do not want to cut the high frequencies of the feedback, set this parameter to BYPASS.

Balance (Delay Balance) #

Adjust the volume balance between the chorus sound that is sent through the delay and the chorus sound that is not sent through the delay. With a setting of “D100: 0W,” only the chorus sound will be output. With a setting of “D0: 100W,” only the chorus sound that is sent through the delay will be output.

62