Roland XV-5080 MFXA-C Control 1-4 Source, MFXA-C Control Destination, Chorus Source PRF/P1-32

Chapter 2 Using the XV-5080 Effects

*When you press [F2 (MFX)] once again, the MFX Param page will reappear.

MFXA–C Control 1–4 Source

Select the Control Source to be used for changing the Multi- effects parameters, and set the Sens and parameters to be changed by that Control Source.

OFF: No controller is used.

CC01–95:Controller numbers 1–95 (except for 32)

PITCH BEND: Pitch Bend

AFTERTOUCH: Aftertouch

SYS-CTRL1–4:System control 1–4

MFXA–C Control Destination 1–4

Selects the Multi-effects parameter to be controlled using the MFX Control 1–4 source. The parameters that can be selected depend on which type of Multi-effects is set to MFX Type.

MFXA–C Control 1–4 Sens -63– +63

If you wish to modify the selected parameter in a positive (+) direction—i.e., a higher value, toward the right, or faster, etc.—from its current setting, select a positive (+) value. If you wish to modify the selected parameter in a negative (-) direction—i.e., a lower value, toward the left, or slower, etc.—from its current setting, select a negative (-) value. Higher numbers produce a greater amount of change.

Making Chorus Settings

The XV-5080’s Chorus effect unit can also be used as a stereo delay unit.

These settings allow you to select chorus or delay, the characteristics of the selected effect type, and the Chorus output routing.

On the Effects General page, set the following parameters.

Chorus Type

0 (Off): Neither Chorus or Delay is used.

1 (Chrus): Chorus is used.

2 (Delay): Delay is used.

Chorus Source PRF/P1–32

Set this when assigning chorus settings that are used by another part. Select PRF when using the Performance's chorus settings. When using the chorus settings assigned to one of the parts, select the part number (P1–32).

Chorus Output Select

This parameter allows you to send the Chorus output directly to the currently selected OUTPUT jacks, to the Reverb, or to both.

MAIN: The Chorus output is sent only to the OUTPUT jacks.

OUTPUT

REV: The Chorus output is sent only to the Reverb.

Chorus Input	Reverb
Chorus		OUTPUT

M+R: The Chorus output is sent to the OUTPUT jacks and to the Reverb.

Chorus Input	OUTPUT
Chorus
Reverb Input	OUTPUT
Reverb

Chorus Level 0–127

Determines the Chorus output level.

Chorus Output Assign A–D

Selects the pair of OUTPUT jacks to which the Chorus unit’s stereo output is routed when Chorus Output Select is set to “MAIN” or “M+R.”

32