Roland XV-5080 OVERDRIVE→ Delay, DISTORTION→ Chorus, DISTORTION→ Flanger, DISTORTION→ Delay

Chapter 2 Using the XV-5080 Effects

28: OVERDRIVE→ DELAY

This effect connects an overdrive and a delay in series.

L in	L out
	Balance D
	Balance W
Overdrive	Delay
	Balance W
	Feedback
R in	R out
	Balance D

Overdrive

Drive

Adjust the degree of overdrive distortion. The volume will change together with the degree of distortion.

Pan (Overdrive Pan) #

Adjust the stereo location of the overdrive sound. L64 is far left, 0 is center, and 63R is far right.

Delay

Time (Delay Time)

29: DISTORTION→ CHORUS

This effect connects distortion and chorus in series. The parameters are essentially the same as “26: OVERDRIVE?CHORUS,” with the exception of the following two.

Drive → Specify the amount of distortion.

Pan → Specify the stereo location of the distortion sound.

L in L out

Balance D

	Balance W
Distortion	Chorus
	Balance W
R in	R out
	Balance D

30: DISTORTION→ FLANGER

This effect connects distortion and flanger in series. The parameters are essentially the same as in “27: OVERDRIVE?FLANGER,” with the exception of the following two.

Drive → Specify the amount of distortion.

Pan → Specify the stereo location of the distortion sound.

Adjust the time delay from when the direct sound begins until the delay sound is heard.

Feedback (Delay Feedback)

Adjust the proportion (%) of the delay sound that is fed back into the effect. Negative (-) settings will invert the phase.

HF Damp (Delay HF Damp)

L in

Distortion

R in

Balance D

L out

Feedback

Balance W

Flanger

Balance W

R out Balance D

Adjust the frequency above which delayed sound fed back to the effect will be cut. If you do not want to cut the high frequencies of the feedback, set this parameter to BYPASS.

Balance (Delay Balance) #

Adjust the volume balance between the overdrive sound that is sent through the delay and the overdrive sound that is not sent through the delay. With a setting of “D100: 0W,” only the overdrive sound will be output. With a setting of “D0: 100W,” only the overdrive sound that is sent through the delay will be output.

Output

Level (Output Level)

Adjust the output level.

31: DISTORTION→ DELAY

This effect connects distortion and delay in series. The parameters are essentially the same as in “28: OVERDRIVE?DELAY,” with the exception of the following two.

Drive → Specify the amount of distortion.

Pan → Specify the stereo location of the distortion sound.

L in L out

	Balance D
	Balance W
Distortion	Delay
	Balance W
	Feedback
R in	R out
	Balance D

60