Roland XV-5080 Creating a Performance Part Keyboard Range Lower, Part Keyboard Range Upper, 162

Chapter 5 Creating a Performance

K.L (Part Keyboard Range Lower)

Range: C -1–G9

Specifies the lowest note that will cause the Part to play its sound.

K.U (Part Keyboard Range Upper)

Range: C -1–G9

Specifies the highest note that will cause the Part to play its sound.

The Lower value cannot be set to a value greater than Upper value, or vice versa. If you attempt to do this, the two values will change simultaneously.

U.F (Part Keyboard Fade Width Upper)

Range: 0–127

This determines what will happen to the Part’s level when a note that’s higher than its specified keyboard range is played. Higher settings produce a more gradual change in volume. If you don’t want the Tone to sound at all when a note above the keyboard range is played, set this parameter to 0.

Selecting the Patch, and Setting

the Volume, Pan, Pitch, and

Polyphony

PERFORMANCE Part #1 page ([PERFORM] - [F3 (Part)])

Patch (Part Patch)

Type (Part Type)

Range: PAT/RHY

Selects the Patch (PAT) or Rhythm Set (RHY) the Part will play.

Group (Part Group)

Available Settings:

Selects the group to which the desired Patch or Rhythm Set belongs.

*You can also use the Patch Finder feature. (p. 19)

*You can also select from the FAVORITE LIST. (p. 207)

*It is not possible to select XP-A–H unless a wave expansion board is inserted into the corresponding slot. (Quick Start; p. 3)

*It is not possible to select CARD unless a SmartMedia card is inserted into the XV-5080 CARD slot.

Number

Selects the desired Patch or Rhythm Set by its number.

*You can also use the Patch Finder feature. (p. 19)

*You can also select from the FAVORITE LIST. (p. 207)

Level&Pan (Part Level&Pan)

Part Level

Available Settings:

Sets the volume of the Part. This setting’s main purpose is to adjust the volume balance between Parts.

Part Pan

Available Settings:

Specifies the stereo position of the Part’s sound. L64 is far left, 0 is center, and 63R is far right.

Tune (Part Tune)

Octave Shift (Part Octave Shift)

Range: -3– +3

Adjusts the pitch of the Part’s sound up or down in units of an octave (+/-3 octaves).

Coarse (Part Coarse Tune)

Range: -48– +48

Adjusts the pitch of the Part’s sound up or down in semitone steps over a range of +/-4 octaves.

Fine (Part Fine Tune)

Range: -50– +50

Adjusts the pitch of the Part’s sound up or down in one-cent steps (1/100th of a semitone) over a range of half a semitone up or down.

162