Roland XV-5080 owner manual Connecting a CD-ROM Drive, With Sampler Libraries, 185, F5 Refresh

Connecting a CD-ROM Drive

XV-5080

CD-ROM drive

SCSI

Cable

1.Turn off the power of the XV-5080 and any connected external devices.

2.Connect the XV-5080 and the CD-ROM drive with a SCSI cable (one equipped with a 25-pin D-sub type connector at the XV-5080 end).

3.Set the SCSI ID with the SCSI switch on the rear panel. Any number is acceptable, as long as each device has a different SCSI ID.

*For more on the CD-ROM drive SCSI ID settings, please refer to the owner’s manual for the device you are using.

The SCSI ID switch settings “8” and “9” cannot be used with the XV-5080.

4.Set the CD-ROM drive’s terminator to ON.

*For more on the CD-ROM drive terminator settings, please refer to the owner’s manual for the device you are using.

*For more on making SCSI connections, please refer to p. 239 of the Owner’s Manual.

With Sampler Libraries

1.Turn on the power to the CD-ROM drive and the XV- 5080.

2.Place the CD-ROM (sampler library) that you want to load in the CD-ROM drive.

3.Press [DISK].

The Disk Menu page will appear.

4.Press [F1 (Load)].

The Load page will appear.

5.Press [F1 (Drive)].

The Drive window will appear.

Chapter 7 Loading a Variety of Data

The SCSI ID and Volume Label of the connected SCSI device appear in the window.

6.Turn the VALUE dial to select the SCSI ID that was set when the CD-ROM drive was connected.

7.Press [F6 (OK)].

The CD-ROM’s contents are displayed.

*Items enclosed by <> indicate folders. Folders cannot be loaded.

*The types of folders displayed vary depending on the library being loaded. “Refer to “About the Sampler Library Folder Types (Indication)” (p. 187).

[F5 (Refresh)]

	Pressing this button clears the XV-5080’s internal cache.
	When sharing a Zip Drive with another XV-5080 (or
	other device), be sure to press this button whenever			Chap.7
	used.
	loading data from the other device concurrently being
8.
		Turn the VALUE dial or press [ ] or [ ] to select the
		folder containing the file to be loaded.
9.		Press [	], and the files available for loading will be
		displayed.
*		Press [	] to move up one level in the hierarchy.

By pressing [F2 (View)], you can specify the category for files to be displayed.

Turn the VALUE dial or press [] or [] to select the category you want to load, and then press [F5 (On/Off)]. Press [F4 (All)] if you want to set markers in all files. Press this once more to remove all markers. And then press [F6 (OK)] to finalize the category.

For more on category contents, refer to p. 188.

185