Roland XV-5080 owner manual ENHANCER→ Chorus, ENHANCER→ Flanger

32: ENHANCER→ CHORUS

This effect connects an enhancer and a chorus in series.

L in	Enhancer	L out
	Mix	Balance D

Balance W

Chorus

		Balance W
R in	Enhancer	R out
	Mix	Balance D

Enhancer

Sens (Enhancer Sens) #

Adjust the sensitivity of the enhancer.

Mix Level (Enhancer Mix Level)

Adjust the ratio with which the overtones generated by the enhancer are combined with the direct sound.

Chorus

Pre Delay (Chorus Pre Delay Time)

Adjust the time delay from when the direct sound begins until the chorus sound is heard.

Rate (Chorus Rate)

Adjust the modulation speed of the chorus effect.

Depth (Chorus Depth)

Adjust the modulation depth of the chorus effect.

Balance (Chorus Balance) #

Adjust the volume balance between the enhancer sound that is sent through the chorus and the enhancer sound that is not sent through the chorus. With a setting of “D100: 0W,” only the enhancer sound will be output. With a setting of “D0: 100W,” only the enhancer sound that is sent through the chorus will be output.

Output

Level (Output Level)

Adjust the output level.

Chapter 2 Using the XV-5080 Effects

33: ENHANCER→ FLANGER

This effect connects an enhancer and a flanger in series.

		Balance D
L in	Enhancer	L out
	Mix	Feedback

Balance W

Flanger

		Balance W
R in	Enhancer	R out
	Mix	Balance D

Enhancer

Sens #

Adjust the sensitivity of the enhancer.

Mix Level (Enhancer Mix Level)

Adjust the ratio with which the overtones generated by the enhancer are combined with the direct sound.

Flanger

Pre Delay (Flanger Pre Delay Time)

Adjust the time delay from when the direct sound begins until the flanger sound is heard.

Rate (Flanger Rate)

Adjust the modulation speed of the flanger effect.

Depth (Flanger Depth)

Adjust the modulation depth of the flanger effect.

Feedback (Flanger Feedback Level)

Adjust the proportion (%) of the flanger sound that is fed back into the effect. Negative (-) settings will invert the phase.

Balance (Flanger Balance) #

Adjust the volume balance between the enhancer sound that is sent through the flanger and the enhancer sound that is not sent through the flanger. With a setting of “D100: 0W,” only the enhancer sound will be output. With a setting of “D0:

100W,” only the enhancer sound that is sent through the flanger will be output.

Output

Level (Output Level)

Adjust the output level.

Chap.2

61