Roland XV-5080 owner manual Reverse Delay, Shuffle Delay, Feedback 1, 4 #, HF Damp 1, Value

68: REVERSE DELAY 2

This allows you to set even longer delay times (max. 1500 ms) for the Multi-Tap Delay function.

L in			2-Band	L out
Feedback	D1	1	EQ
	D2
Rev. Delay	Delay	2
	D4	D3
		3
R in			2-Band	R out
			EQ

Delay

1–4 (Delay Time 1–4)

Adjusts the delay time from the direct sound until the delay 1 – 4 sound is heard.

Feedback

1, 4 (Feedback 1, 4) #

Adjusts the proportion (%) of the delay 1 sound that is fed back into the effect. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase.

HF Damp

1, 4 (HF Damp 1, 4)

Adjusts the frequency above which delayed sound (delay 1, 4) fed back to the delay input will be cut.

If you do not want to damp the high frequencies, set this parameter to BYPASS.

Level

1–3 (Delay Level 1–3)

Sets the volume level of the delay sound (Delay 1 – 3).

Pan

1–3 (Output Pan 1–3)

Sets the stereo position of the delay sound (Delay 1). L64 is far left, 0 is center, and 63R is far right.

Threshold

Value

Specifies the volume level at which the reverse delay will begin to apply.

Chapter 2 Using the XV-5080 Effects

EQ Gain

Low (Low Gain)

Adjusts the gain of the low frequency range. Positive (+) settings will emphasize (boost) the low- frequency range.

High (High Gain)

Adjusts the gain of the high frequency range. Positive (+) settings will emphasize (boost) the high- frequency range.

Balance

Balance (Effect Balance) #

Sets the volume balance between the direct sound and the effect sound.

With a setting of D100:0W only the direct sound will be output, and with a setting of D0:100W the effect sound will be output.

Output

Level (Output Level)

Adjusts the output level.

69: SHUFFLE DELAY 2

This allows you to set even longer delay times (max. 3000 ms) for the Shuffle Delay function.

L in	2-Band	L out
Feedback	EQ
Delay 1	1
Delay
Delay 2	2
R in	2-Band	R out
	EQ

Delay

Time (Delay Time) #

Adjusts the delay time from the direct sound until the delay sound is heard.

Shuffle Rate #

Sets the ratio (as a percentage) of the time that elapses before the sound plays in Delay B relative to the time that elapses before the sound plays in Delay A. When set to 100%, the delay times are the same.

Acceleration

Adjusts the time over which the Delay Time will change from the current setting to a newly specified setting.

Chap.2

83