Remote Control Unit (continued)
PROGRAM button | For details, see ``Setting the Timer''. | |||
|
|
| Press this button to select the mode you want to program. | |
|
|
|
| |
TIMER SELECT button | No display : The timer does not operate. | |||
|
|
| OFF | : The air conditioner stops at the set time. |
|
|
| ON | : The air conditioner starts at the set time. |
|
|
|
| : The air conditioner stops and starts, or starts and stops, at |
|
|
|
| the set times every day. |
|
|
|
| |
MODE selector button | Use this button to select COOL or FAN mode | |||
| (COOL) |
| : The air conditioner makes the room cooler. | |
| (FAN) |
| : The air conditioner works only as a circulation fan. | |
|
|
|
| |
FLAP button | Press this button to select the sweep function, which moves the flap up | |||
|
|
| and down automatically. | |
|
|
|
| : The flap moves up and down automatically. |
|
|
|
|
|
FAN SPEED selector |
| : The air conditioner automatically decides the fan speeds. | ||
| button |
| : High fan speed | |
|
|
|
| : Medium fan speed |
|
|
|
| : Low fan speed |
|
|
|
|
|
1 HR. TIMER button | 1 | : When you press this button, regardless of whether the unit is | ||
| operating or stopping, the unit operates for one hour and then | |||
|
|
|
| shuts down. |
|
|
|
| |
ACL button | Puts the remote control unit into | |||
(ALL CLEAR) | button after replacing the batteries. | |||
|
|
|
| |
A/C SENSOR button | When you press this button (use a | |||
|
|
| ballpoint pen), the mark will appear at the display. And the room | |
|
|
| temperature is detected by the sensor which is built into the indoor unit | |
|
|
| and the air conditioner is controlled accordingly. | |
|
|
| If the remote control is located near a heat source, such as a space | |
| NOTE |
| ||
|
| heater or in direct sunlight, press the A/C SENSOR button to switch to | ||
|
|
| ||
|
|
| the sensor on the indoor unit. | |
|
|
|
|
|
NOTE
·
·
The remote control unit sends the temperature signal to the air conditioner regularly at three minute intervals. If the signal from the remote control unit stops for more than ten minutes due to the loss of the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner's position.
Operation when the outdoor temperature is low
If an indoor unit connected to a 
(low fan speed) can result in intermittent operation to prevent freezing. In such cases, use the 
(high fan speed) or 
(medium fan speed) setting instead.
10 |
