Adjusting the Airflow Direction
Indoor unit
(Wall mounted type)
Zone 30° ``A''
for
COOLING
A. Horizontal (Wall mounted type only)
The horizontal airflow can be adjusted by moving the vertical vane to the left or right.
Left
Right
Vertical vane
B. Vertical
Confirm that the remote control unit has been turned on. Press the FLAP button to start the flap moving up and down (). If you want to stop the flap movement and to direct the air in the desired direction, press the FLAP button again. In the COOL mode, don't direct the flap down more than 30 ° (KS, TS Types), or leave it in the vertical position (XS Type), otherwise condensation may drip onto the floor. Zone ``A'' (KS, TS Type) and any position other than vertical (XS Type) are the recommended flap positions for cooling.
CAUTION
Do not move the flap with your hands.
ON I /OFF
OFF ON NIGHT
MODE CLOCK SETBACK
FLAP HH TIMER
FAN SPEED | MM | SELECT |
SELECT | TIME SET | ACL A/C |
SENSOR | ||
| BATTERIES |
|
Up
Flap
Air outlet Down grille
Operation without the Remote
Control Unit
INDOOR UNIT
Operation Flap selector
(Wall mounted type)
If you have lost the remote control unit or it has trouble, follow the steps below.
1.When the air conditioner is stopped.
If you want to turn on the air conditioner, switch the operation selector to the OFF position, and then to the ON position.
NOTE The set temperature and fan speed are automatically set at the last selection before stopping.
2.When the air conditioner is running.
If you want to turn off the air conditioner, switch the operation selector to the OFF position.
20 |