Roland XV-5080 owner manual Performance Mode Settings

Chapter 2 Using the XV-5080 Effects

Performance Mode Settings

Three different Multi-effects can be used in a Performance.

Select which of these three Multi-effects to use with Part Output MFX Select. With this parameter, the same Multi- effects are applied to all selected Parts. You can adjust the amount of effect to be applied to the Parts by adjusting their Send Levels to each of the effect units. (Fig. 1)

The Send Level setting for each Tone can also influence effect intensity (Fig. 2).

Furthermore, you can take the Multi-effects you have applied to a Patch in a Part and apply them to the entire Performance, or just part of the Performance.

Fig.1 – When Output Assign is set to “MFX” in the Performance mode (the output settings for Tone are ignored)

Performance
Part 1
Patch
Part32
TONE	Multi-Effects
	Chorus
	Reverb

Fig.2 – When Output Assign is set to “PATCH” in the Performance mode (the output settings for Tone are valid)

Performance
Part 1
Patch
Part32
TONE	Multi-Effects
	Chorus
	Reverb

The primary role of the effect settings is to determine the Part Output Assign.

You can select from the following Part Output Assign settings values to suit your purposes.

MFX: Selected when Multi-effects, chorus, and reverb are

used.

A-D:Selected when outputting in stereo without use of the Multi-effects. Chorus and reverb can be used.

1-8:Selected when outputting in mono without Multi- effects. Chorus and reverb can be used. When this setting is

used, chorus and reverb sounds are output in stereo according to the Chorus Output Assign and Reverb Output Assign settings.

PAT: The Part’s output destination is determined by the settings of the Patch or Rhythm Set assigned to the Part.

The screen appears as shown below, according to the settings values.

•For MFX

•For A–D

•For 1–8

The following shows the basic setting procedure.

1.Select the Performance you wish to use.

2.Press [F5 (Effects)].

The Perform Effect page will appear.

3.Press [F1 (General)].

The General page will appear.

4.Press [ ]/[ ]/[ ]/[ ] to move the cursor to the parameter you want to set.

5.Turn the VALUE dial, or press [INC]/[DEC] to select the desired value.

*If you make a mistake when setting a parameter’s value, or you don’t like the change you have made, just press [UNDO] to restore the value the parameter originally had.

6.Repeat Steps 3 to 5 to set the Effect.

7.Press [EXIT] to return to the PERFORM Play page.

30