Simrad H1000 Setting the boat lag value, Boat lag value table, Automatic rudder gain, Boat Type

calibration

seatrial calibration

h1000 pilot

		setting the boat lag value
		The autopilot must be disengaged to adjust the
		boat lag value.
boat lag value table
Boat Type	Default Value		Typical Value
Sail Boats	0.30		0.3 to 1.0
Power Boats	0.50		0.3 to 1.0

automatic rudder gain

When the h1000 pilot is part of an integrated h1000 system, boat speed data is supplied via the Speed/Depth Interface unit. This allows the autopilot to automatically ‘learn’ the correct value for rudder gain by monitoring boat speed and rate of turn. The rate of turn will be approximately 7.5θ per second.

If there is no direct speed input or the speed is being set by the manual speed band selections, then the rudder gain value must be entered manually. Refer to Manual Rudder Gain.

checking the automatic rudder gain learning

1.Steer the boat onto a suitable heading and allow time for the boat to settle on this course.

2.Select Compass Mode by repeatedly pressing the MODE key.

3.Press the ON key on any h1000 pilot display or hand-held controller.

4.The autopilot will now steer the boat on the selected heading.

5.At a speed not exceeding 15 knots, make at least six large course changes of at least 120θ, by multiple presses of the 10θ course change buttons on any h1000 pilot display or hand-held controller. This enables the autopilot to learn the rudder gain value.

6.When the autopilot has learnt the rudder gain value, the rate of turn will be approximately 7.5θ per second. (To estimate the rate of turn the display is updated every 1 second, therefore the heading display should jump in 7θ to 8θ steps.)

7.Press the red OFF key to disengage the autopilot and return to manual steering.

Page 62