description/installation |
| h1000 pilot |
| ||
ram solenoid wiring details |
|
|
the following information applies to the size 0, 1, 2 and 3 blue rams only.
1.Remove the solenoid wiring connector by unscrewing the centre screw.
2.Remove the screw from the connector housing.
3.Remove the rubber gasket.
4.Use a small screwdriver through the screw hole to carefully push against the connector block. This will push the front of the connector block out ready for wiring.
5.Run the cable through the cable entry in the cover and then connect as follows:
Pin 1: | Blue Wire |
Pin 2: | Brown Wire |
6. The cable screen must be cut back and sleeved.
Refit the two halves of the connector together, tighten the plastic cable clamp nut, replace the rubber seal and fit the connector onto the solenoid using the centre screw to fully secure it.
Page 38
