h1000 pilot
calibration
calibrating the pilot
|
|
|
|
|
|
| Calibration | |||
|
|
|
|
|
|
| With the system ON, press | ENTER | and select | |
|
|
|
|
|
|
| calibration |
|
|
|
|
|
|
|
|
|
| calibration menu | |||
|
| Calibration |
| |||||||
|
|
|
|
| The procedures for calibration can be divided into two | |||||
| Speed |
|
|
| ||||||
|
|
|
| sections. The first is carried out at the dockside | ||||||
| Depth |
|
|
| ||||||
| Wind |
|
|
| (Dockside Calibration) and the second is carried out | |||||
| Compass |
|
|
| or checked during the course of a sea trial (Sea Trial | |||||
|
| Pilot dockside |
|
|
|
| ||||
|
| Pilot sea trial |
| OK |
|
| Calibration). | |||
| Security |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| pilot calibration parameters | |||
The following is a list of the pilot calibration parameters that must be set for successful pilot operation.
Boat type | Select boat type: sail, power planing, power displacement |
Rudder stop port | Set port rudder stop position |
Rudder stop stbd | Set starboard rudder stop position |
Drive type | Select drive type connected to pilot |
Hardover time | Measures the hardover port to hardover starboard time |
Waterline length | Set the waterline length of the boat |
Dip angle | Set the magnetic dip angle |
Joystick control | Set the joystick steering mode: normal, proportional |
Rudder amidships | Set the rudder amidships position |
Boat lag | Set the boat lag value |
Rudder gain | Set the rudder gain value |
dockside calibration
The following parameters must be set prior to a pilot sea trial. The procedures to do this are described in this section of the manual:
ξ Boat type
ξ Rudder stop port ξ Rudder stop stbd ξ Drive type
ξ Hardover time ξ Waterline length ξ Joystick control
Page 53
