Roland XV-5080 owner manual Stereo Auto WAH, ST Formant Filter Stereo Formant Filter

Output

Level (Output Level)

Adjusts the output level.

65: STEREO AUTO WAH

This is a stereo auto wah.

L in Auto Wah 2-Band EQ L out

R in Auto Wah 2-Band EQ R out

Auto Wah

Filter Type

Selects the type of filter.

LPF: The wah effect will be applied over a wide frequency range.

BPF: The wah effect will be applied over a narrow frequency range.

Sens #

Adjusts the sensitivity with which the filter is controlled.

Manual #

Adjusts the center frequency from which the wah effect is applied.

Peak

Adjusts the amount of the wah effect that will occur in the area of the center frequency.

Lower settings will cause the effect to be applied in a broad area around the center frequency. Higher settings will cause the effect to be applied in a more narrow range.

Rate (LFO Rate) #

Adjusts the frequency of the modulation.

Depth (LFO Depth) #

Adjusts the depth of the modulation.

Polarity (Auto Wah Polarity)

Sets the direction in which the frequency will change when the auto-wah filter is modulated. With a setting of Up, the filter will change toward a higher frequency. With a setting of Down, it will change toward a lower frequency.

Phase #

Sets the degree of phase shift of the left and right sounds when the wah effect is applied.

Chapter 2 Using the XV-5080 Effects

EQ Gain

Low

Adjusts the gain of the low frequency range. Positive (+) settings will emphasize (boost) the low- frequency range.

High

Adjusts the gain of the high frequency range. Positive (+) settings will emphasize (boost) the high- frequency range.

Output

Level (Output Level)

Adjusts the output level.

66:ST FORMANT FILTER (Stereo Formant Filter)

This is a stereo formant filter.

L in	Overdrive	Formant	2-Band EQ	L out
R in				R out
	Overdrive	Formant	2-Band EQ

Overdrive

Switch (Drive Switch)

Turns Drive on/off.

Drive #

Adjusts the degree of distortion. The volume will change together with the degree of distortion.

Filter

Vowel1

Selects vowel 1.

Vowel2

Selects vowel 2.

Rate #

Sets the frequency at which the two vowels will be switched.

Depth #

Sets the effect depth.

Manual #

Sets the point at which the two vowels will be switched. When set to 50, Vowels 1 and 2 are switched after the same

Chap.2

81