Roland XV-5080 owner manual 41STEREO Phaser, 42KEYSYNC Flanger

41:STEREO PHASER

This is a stereo phaser. With the Step effects, you can also make stepped changes in the pitch of sounds to which the Phaser effect is applied.

L in	Phaser	2-Band	L out
		EQ
		Mix
		Mix
R in	Phaser	2-Band	R out
		EQ

Phaser

Type (Phaser Type)

Selects the type of Phaser.

Type 2 adds more of the Phaser effect to the high frequencies than Type 1.

Mode

Selects the number of stages in the phaser (4/8-STAGE).

Polarity

Selects whether the left and right phase of the modulation will be the same or the opposite.

INVERSE:The left and right phase will be opposite. When using a mono source, this spreads the sound. SYNCHRO:The left and right phase will be the same. Select this when inputting a stereo source.

Manual #

Adjusts the center frequency to which the phase effect is applied.

Rate (Phaser Rate) #

Adjust the frequency of modulation.

Depth (Phaser Depth)

Adjust the depth of modulation.

Resonance (Phaser Resonance)

Adjust the amount of feedback for the phaser. Higher settings will give the sound a stronger character.

X-Feedback (Cross Feedback Level)

Adjust the proportion (%) of the phaser sound that is to be returned to the input. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase.

Mix Level

Adjust the volume of the phase-shifted sound, relative to the

Chapter 2 Using the XV-5080 Effects

direct sound.

Step Rate

Switch

This setting determines whether the pitch is changed in a stepped fashion (ON) or not (OFF).

Rate (Step Rate) #

Adjust the frequency of pitch change.

EQ Gain

Low (Low Gain)

Adjust the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.

High (High Gain)

Adjust the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.

Output

Level (Output Level)

Adjust the output level.

42:KEYSYNC FLANGER

Keysync FLanger controls the Flanger by resetting the effect at the volume of the sound input to the effects device, restarting from the same pitch each time the Flanger is reset. This parameter lets your playing dynamics on the keyboard control the flanger effect.

L in	2-Band	L out
	EQ
	Flanger
	Feedback
	Feedback
	Flanger
R in	2-Band	R out
	EQ

Flanger

PrDly (Pre Delay Time)

Adjust the time delay from the original sound until the

flanger sound is heard.

Rate (LFO Rate) #

Adjust the modulation frequency of the flanger sound.

Chap.2

65