Roland XV-5080 Selecting Common Controllers System Utility F4 Control, Simm, Battery Check

Chapter 9 Other Settings/Status Checks

Selecting Common

Controllers ([SYSTEM/

UTILITY] - [F4 (Control)])

These settings allow you to choose four MIDI controllers for global use when controlling the parameters of any Patch or Performance. The settings in each Patch or Performance will determine whether the two controllers you choose here will actually be used. In each Patch or Performance, you will also need to specify the parameters to be controlled.

System Control 1–4 (System Control Source 1–4)

Available Settings:

OFF: No controller is used.

CC01–95:Controller numbers 1–95 (except for 32)

PITCH BEND: Pitch Bend

AFTERTOUCH: Aftertouch

Setting Procedure:

1.Press [SYSTEM/UTILITY], getting the indicator to light.

*If the indicator is blinking, you are in UTILITY mode. Press [SYSTEM/UTILITY] once again to make its indicator light.

2.Press [F4 (Control)] to call up the SYSTEM Control page.

3.Press [ ]/[ ]/[ ]/[ ] to move the cursor to the System Control (System Control Source) you wish to

set.

4.Turn the VALUE dial or by press [INC]/[DEC], to select the desired value.

*If you’ve made a mistake, simply press [UNDO]. The value of the parameter will be restored to what it was when you first positioned the cursor there.

5.Press [EXIT] to return to the applicable PLAY page.

Confirming the Current Status ([SYSTEM/UTILITY] - [F6 (Info)])

The basic steps needed to carry out the procedure are as follows:

1.Press [SYSTEM/UTILITY], and confirm that its indicator has lighted.

*If the indicator is blinking, you are in UTILITY mode. Press [SYSTEM/UTILITY] once again to get the indicator to light steadily.

2.Press [F6 (Info)] to call up the SYSTEM Info page.

3.Press [EXIT] to return to the Play page.

Wave Expansion A–D (Wave Expansion Board Name A–D)

The display shows the names of Wave Expansion Boards (SR-JV80 Series) installed in slots EXP A–D.

Slots without any boards installed are shown as “---------.”

SRX (SRX Board Name E–H)

The display shows the names of Wave Expansion Boards (SRX Series) installed in slots EXP E–H.

Slots without any boards installed are shown as “---------.”

SIMM

This displays the installation status of any memory modules (SIMMs), used for Wave data.

BATTERY CHECK

The XV-5080 contains a battery that retains the data in its internal memory when the unit’s power is turned off. This displays the status of the battery. If the display says “OK,” there is sufficient voltage. If the display says “LOW,” the battery voltage has run down. Contact your nearby Roland service station as soon as possible to have the battery replaced.

Chap.9

215