Chapter 3 Selecting Output Jacks

SYSTEM Output page ([SYSTEM] - [F2 (OutP&EQ)])

Output Mix/Parallel

Mode

Available Settings:

MIX: Signals that are set to be output from jacks other than the A (MIX) OUTPUT jacks are mixed and output from the A (MIX) OUTPUT jacks. This setting allows you to quickly route everything through headphones when you are creating sounds, or to combine all of your sounds into two outputs when sending the XV-5080’s signal to a mixer that has only two channels.

When MIX is selected, sounds routed to the INDIVIDUAL OUTPUT 3/5/7 jacks are sent to the left A (MIX) OUTPUT jack, and sounds routed to the INDIVIDUAL OUTPUT 4/6/ 8 jacks are sent to the right A (MIX) OUTPUT jack. PARALLEL: Sounds are routed to output jacks according to their output settings.

The XV-5080’s Master Level and Mix/Parallel settings are each established using a single global parameter.

SYSTEM General #1 page ([SYSTEM] - [F1 (General)])

Master

Level (Master Level)

Range: 0–127

Adjusts the volume of the entire XV-5080.

Example Settings

Setting the Output Destination of a Specific Rhythm Tone This example explains the procedure for outputting the Rhythm Tone assigned to C4 from the INDIVIDUAL 3 OUTPUT jack without sending it through any internal effects.

1.Select the Rhythm Set you wish to set.

2.Press [F6 (Effects)].

3.Press [F1 (General)] to call up the RHYTHM Effects General page.

4.Press TONE SELECT [1]–[4] and set the key at the upper left corner of the display to “C4.”

*If a MIDI keyboard is connected, you can select C4 by pressing the C4 key on the keyboard.

5.Press [ ]/[ ]/[ ]/[ ] to move the cursor to Rhythm Tone Output Assign.

6.Turn the VALUE dial or press [INC]/[DEC] to select “3.”

7.Press [ ]/[ ]/[ ]/[ ] to move the cursor to Rhythm Tone Dry Send Level.

8.Turn the VALUE dial to select “100.”

9.Press [ ]/[ ]/[ ]/[ ] to move the cursor to Rhythm Tone Chorus Send Level.

10.Turn the VALUE dial to select “0.”

11.Set the Rhythm Tone Reverb Send Level setting to “0” in the same way.

12.Press [EXIT] to return to the RHYTHM PLAY page.

13.Press [F1 (Common)].

14.Press [ ]/[ ] to move the cursor to Output Assign.

15.Turn the VALUE dial or press [INC]/[DEC] to select “TONE.”

16.Press [EXIT] to return to the RHYTHM PLAY page.

116

Page 116
Image 116
Roland XV-5080 owner manual 116, Mode