Roland XV-5080 WMT Velocity Fade Width Lower, WMT Velocity Range Lower, WMT Velocity Range Upper

Chapter 6 Creating Rhythm Sets

Time4 (Pitch Envelope Time 4 Velocity Sensitivity)

Range: -63– +63

Use this parameter when you want keyboard playing dynamics (velocity) to affect T4 (Time 4) of the pitch envelope. With higher settings, the T4 value will change more significantly depending on whether you release the key slowly or quickly. With positive (+) settings, greater keyboard velocity will reduce the T4 setting. With negative (-) settings, greater keyboard velocity will increase the T4 setting.

RHYTHM WG WMT Vel Range page ([RHYTHM] - [F2 (WG)] - [F4 (V.Range)])

Velocity Control

Switch

Determines whether Velocity range will be recognized (ON), or ignored (OFF). When set to RANDOM, the Wave will sound randomly, regardless of any Velocity messages.

L.F (WMT Velocity Fade Width Lower)

Range: 0–127

Determines what will happen to the Tone’s level when the Tone is played at a velocity lower than its specified velocity range. Higher settings result in a more gradual change in volume. If you don’t want notes played outside the specified velocity range to be heard at all, set this to 0.

Level

1	Lower	Upper	Velocity
	L.Fade value	U.Fade value

V.L (WMT Velocity Range Lower)

Range: 1–UPPER

Specifies the highest limit of playing dynamics (key velocity) which will sound the Tone. Make these settings when you want different Tones to sound in response to notes played at different strengths.

V.U (WMT Velocity Range Upper)

Range: LOWER–127

Specifies the highest limit of playing dynamics (key velocity) which will sound the Tone. Make these settings when you want different Tones to sound in response to notes played at different strengths.

*It is not possible to set the Lower value higher than the Upper value, or the Upper value below the Lower value. If you attempt to do so, the two values will change simultaneously.

U.F (WMT Velocity Fade Width Upper)

Range: 0–127

Determines what will happen to the Tone’s level when the Tone is played at a velocity greater than its specified velocity range. Higher settings result in a more gradual change in volume. If you don’t want notes played outside the specified velocity range to be heard at all, set this to 0.

Velocity Range

Status of these settings will be displayed.

RHYTHM WG Sample page ([RHYTHM] - [F2 (WG)] - [F5 (Sample)])

You can edit the Sample (Wave data) loaded into the SIMM (memory module).

* These settings cannot be made unless a Sample is being used.

Sample

Sampling Freq. (Sampling Frequency)

Displays the original sampling frequency of the loaded

Sample.

Original Key

Displays the original key of the loaded Sample.

174