Roland XV-5080 owner manual System Parameters

Parameter List

■System Parameters

SYSTEM General #1 ([SYSTEM/UTILITY]-[F1(General)])(p. 209)

Group	Parameter		Value
Setup	LCD Contrast	LCD contrast	1–10
	Patch Remain	Patch remain switch	OFF, ON
	Powerup Mode	Power up mode	LAST-SET, DEFAULT
	Character Style	Character Style	TYPE1–4
	Rhythm Edit Key	Rhythm edit key	PANEL, PANEL&MIDI
	SCSI Probe Time	SCSI probe time	1–10
Master	Level	Master level	0–127
	Tune	Master Tune	415.3–466.2Hz
	Key Shift	Key Shift	-24–+24 semitones
System Tempo	Clock Source	Clock source	INT, MID
	Tempo	System tempo	20–250

SYSTEM General #2 ([SYSTEM/UTILITY]-[F1(General)])(p. 211)

Group	Parameter		Value
Scale Tune	Switch	Scale tune switch	OFF, ON
PATCH SCALE	C–B	Scale tune C–B	-64–+63
KEY SCALE	C–B	Scale tune C–B	-64–+63

SYSTEM Output ([SYSTEM/UTILITY]-[F2(Outp&EQ)-[F2(Output)])(p. 211)

Group	Parameter		Value
Digital Interface	Master Clock	Master Clock	INTERNAL/R-BUS/WORD CLOCK IN
	Master Freq	Master Frequency	44.1/48.0kHz
DIF Control	DIF-AT Clk Select	DIF-AT Clock select	R-BUS/ADAT/DA-88
Output Mix/Parallel	Mode	Mix/Parallel	MIX, PARALLEL
Output Gain	Gain	Output Gain	-12, -6, 0, +6, +12 dB

SYSTEM EQ ([SYSTEM/UTILITY]-[F2(Outp&EQ)-[F2(EQ)])(p. 211)

Group	Parameter		Value
Output-A–D	L.F	Low Frequency	200/400Hz
	L.G	Low Gain	-15–+15
	H.F	High Frequency	2000/4000/8000Hz
	H.G	High Gain	-15–+15

SYSTEM MIDI ([SYSTEM/UTILITY]-[F3(MIDI)])(p. 211)

Group	Parameter		Value
MIDI Receive Ch	Perform Ctrl Ch	Performance control channel	1–16, OFF
	Patch/Rhy Rx Ch	Patch/Rhythm set receive channel	1–16
System Exclusive	Device ID	Device ID number	17–32
	Receive Sw	Receive exclusive switch	OFF, ON
MIDI Tx	Transmit Edit Data	Transmit edit data switch	OFF, ON
Stack	Mode	Stack mode	OFF, 2–8
	Number	Stack number	1–8
Rx Switch	Program Chg	Program Change	OFF, ON
	Bank Select	Receive bank select switch	OFF, ON
	GM System ON	Receive GM-ON exclusive switch	OFF, ON
	GM2 System ON	Receive GM2-ON exclusive switch	OFF, ON
	GS Reset	Receive GS Reset exclusive switch	OFF, ON

SYSTEM Control ([SYSTEM/UTILITY]-[F4(Control)])(p. 215)

Group	Parameter		Value
System Control 1-4	Source	System control assign 1-4	OFF, CC01–95(except 32), PITCH BEND, AFTERTOUCH

276