Exabyte 1X7 LTO manual Setting the Ethernet Addresses, Snmp, FTP Interface

CHAPTER 3—CONFIGURING THE AUTOLOADER

Table 3-5Ethernet configuration options (continued)

SNMP	If you are using a network-based monitor/management
	application other than the autoloader’s Remote Management
	utility, you may need to identify the autoloader’s Simple
	Network Management Protocol (SNMP) settings to the
	application. These settings include:
	ƒ	Read community string
	ƒ	Write community string
	ƒ	Broadcast community string
	ƒ	Trap address
	ƒ	Trap port
	You can view and change these settings only through the
	autoloader’s Remote Management utility. See Chapter 4 for
	instructions.
FTP Interface	The autoloader also includes an FTP interface that you can use
	to transfer firmware files or create diagnostic listings. You can:
	ƒ	Set up an FTP user name and password for this interface or
		use the autoloader’s defaults
	ƒ	View and change the FTP settings only through the library’s
		Remote Management utility
	ƒ	For instructions, see Chapter 4.
	For information about accessing the autoloader’s FTP interface
	and using an FTP utility to upgrade firmware or obtain
	diagnostic listings, see page 100.

Setting the Ethernet Addresses

To set Ethernet addresses:

1.At the Home screen, press , , , or to access the main menus. If necessary, enter the operator panel password (see page 42).

2.Press or until the Configuration menu appears:

C h a n g e a

C o n f i g u r a t i o n

3.Press to see the menu selections.

4.Press or until the following screen appears:

C	h a n g e		I P A d d r ?
D	H C P	I s	O N

36

PRODUCT MANUAL 1012581