Exabyte 1X7 LTO manual LED Color Status, Back Panel Components

AUTOLOADER COMPONENTS

Operator Panel (LCD and Keypad) The operator panel includes a five-button keypad and a two-line, 32-character liquid crystal display (LCD). You can use the operator panel to:

Set or change autoloader configuration options Issue commands to the autoloader

View autoloader status and information

Run demonstration programs and test autoloader functions Reset the autoloader

Cartridge Access Port The cartridge access port allows you to insert or remove cartridges from the autoloader. The cartridge access port door is motor-driven, under control of the autoloader. To prevent unauthorized use of the cartridge access port, operator panel menus can be password protected or access can prevented through the application.

In the event of a power failure, you can manually open the cartridge access port door to remove cartridges. A hole in the front of the faceplate provides access to a gear shaft attached to the door. You can use a small screwdriver to turn the gear shaft and open the door.

Status LED The status LED indicates autoloader activity as shown in the following table. See Figure 1-1for the location of the status LED.

LED Color	Status
Off (no color)	The autoloader is idle
Green	The autoloader is performing a mechanical
	operation
Amber	The autoloader encountered a hardware error
	See Appendix C, Error Messages

BACK PANEL COMPONENTS

Figure 1-2shows the back panel components of the autoloader.

Ethernet	SCSI	Tape drive	Fan	Power cord	Power
port	connectors	cover plate		connection	switch

Figure 1-2Magnum 1x7 LTO Autoloader back panel components

OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER

3